Search results
Results from the WOW.Com Content Network
This scale was used by Revell for some ship models because it was one-half the size of the standard scale for wargaming models used by the U.S. Army. 1:535: 0.022: 0.570 mm: Ship models: Scale used by Revell for USS Missouri ship. Sometimes called "box scale" because chosen to fit a box size. 1:500: 0.610 mm: Architecture. Ship models. Die-cast ...
Both classes used the same studio model, differing in sizes in proportion to other starships depending on variant. The B'rel-class is a scout vessel, used for espionage, skirmishes and raids, while the K'Vort-class is a light cruiser. Both classes are armed with disruptor cannons mounted on the tips of the wings and a forward torpedo launcher.
The C-57D was recreated as a large-scale miniature kit by Polar Lights in 2001 and was labeled as being a 1:72 scale, injection-molded, all-plastic model kit, which is 28 inches (71 cm), a scale of 168 feet (51 m) in diameter; 1:72 is a standard international plastic aircraft model scale. The kit included complete "under the dome" interior crew ...
Figures are commonly used with a variety of scales. It is not uncommon for there to be a mismatch between the game scale and miniature size. Chainmail used a scale of 1:360, [6] appropriate to 5 mm miniatures, but was played with 30 mm miniatures, [7] and the conceit that each figure represented 20 men. In the table below, figure height alone ...
The size of TMM 43621-1 is based on Lehman & Coulson 2002 [4] and the sizes of USNM 15560 and BIBE 45854 are from a diagram by Scott Hartman. [ 1 ] • The humans are scaled to 170 cm (5 ft 7 in) and 160 cm (5 ft 3 in) respectively.
The first miniature built from Jefferies' drawings was a 4-inch (100 mm) scale model. [6] Desilu Studios, which produced Star Trek, hired Richard C. Datin to make a pre-production model. [23] [24] Datin used a subcontractor with a large lathe for major subcomponents and otherwise worked on the model for approximately 110 hours during November ...
Usually they are either inches or centimeters, but this depends on the sizes of the models used and the size of the battle board. Normally, rulers or tape measures are used to measure distances between models, as in most traditional figure-based wargames; FT can also be played on a hex-printed battle board where each 1 inch hex represents one ...
The scale of a model vehicle can be expressed as a scale ratio. A scale ratio of 1:100 means that 1 cm represents 100 cm; at this scale, if a model car is 4.5 cm long, then it represents a real car that is 4.5 m long. When it comes to figurines of humans, the preferred method of expressing scale is the height of a figurine in millimeters.