Ads
related to: blown fuel injection valve repair shopswalmart.com has been visited by 1M+ users in the past month
car.lowcostlivin.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
Prior to 1979, the electronics in fuel injection systems used analogue electronics for the control system. The Bosch Motronic multi-point fuel injection system (also amongst the first systems where the ignition system is controlled by the same device as the fuel injection system) was the first mass-produced system to use digital electronics.
These valves are mounted on the outlet fittings of the fuel injection pump, one per cylinder injector. They are always mounted at the pump end of the pipes between the pump and injectors. The check valve aspect is a conical valve or 'mitre valve', [i] held against a matching conical seat by a spring. As these valves must work at high pressure ...
The system increases the engine's power output by allowing fuel to be burned at a higher-than-normal rate, because of the higher partial pressure of oxygen injected with the fuel mixture. [1] Nitrous injection systems may be "dry", where the nitrous oxide is injected separately from fuel, or "wet" in which additional fuel is carried into the ...
Injection phase Partway through the pump stroke, the solenoid is energized, which closes the spill valve. The fuel is forced into the cylinder through the spray tip. Pressure reduction phase Toward the end of the pump stroke, the spill valve is re-opened, allowing the fuel to recirculate again and ending the injection phase.
This is due to the fact that the fuel hits the intake valves on the way to the combustion chamber, allowing the detergents in the fuel to keep them clean. However, carbon build-up on intake valves is a problem for engines with direct injection only, as the fuel is injected directly into the combustion chamber.
An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.
Ads
related to: blown fuel injection valve repair shopswalmart.com has been visited by 1M+ users in the past month
car.lowcostlivin.com has been visited by 100K+ users in the past month