Search results
Results from the WOW.Com Content Network
For the 1993–1996 model XJS, the brakes were moved to the outboard position. This was achieved using the hub carriers from the Second Generation IRS, which by that time had already been in production for seven years for the XJ6 (XJ40). Moving the rear brakes outboard eliminated the heat transfer problem and allowed for easier servicing.
The C5 Corvette's rear suspension. The leaf-spring suspension configuration is independent, because the movement of one wheel is not determined by the position of the other. [6] Control arms are utilized to define the motion of the wheel as the suspension is compressed. The usual coil springs are replaced with a single FRP spring, which spans ...
The Herald, Vitesse, Spitfire, and GT6 all used a rear transverse leaf spring, as well as the 1995-98 Volvo 960/S90/V90 and a rare Swedish sports car incorporating the Volvo 960 rear suspension called the JC Indigo. [1]: 4 This type of suspension should not be confused with earlier, rigid axle applications such as those used on early Ford cars.
Change in camber due to cornering forces can cause loss of rear-wheel adhesion leading to oversteer—a dynamically unstable condition that can cause a vehicle to spin. This is an especially severe problem when a swing axle is used in a rear-engine design, because of the greater side-g forces on the rear wheels from the mass of the engine.
The hydraulic shock absorbers used on the rear suspensions of motorcycles are essentially the same as those used in other vehicle applications. Motorcycle shocks do differ slightly in that they nearly always use a coil-over spring. In other words, the spring for the rear suspension is a coil spring that is installed over, or around, the shock.
For a rear suspension, a pair of joints can be used at both ends of the arm, making them more H-shaped in plan view. Alternatively, a fixed-length driveshaft can perform the function of a wishbone as long as the shape of the other wishbone provides control of the upright.
A mono-tube coilover is a single piston and rod assembly in a damping case in which both compression and rebound occur. A larger mono-tube shock will be able to displace more hydraulic fluid, providing a more sensitive response to small suspension movements than twin-tube shocks.
The front of the H attaches to the body via rubber bushings, and the rear of the H carries each stub-axle assembly, on each side of the car. The cross beam of the H holds the two trailing arms together, and provides the roll stiffness of the suspension, by twisting as the two trailing arms move vertically, relative to each other.