Search results
Results from the WOW.Com Content Network
For instance, if a programmer enhances a part of the code that represents 10% of the total execution time (i.e. of 0.10) and achieves a of 10,000, then becomes 1.11 which means only 11% improvement in total speedup of the program. So, despite a massive improvement in one section, the overall benefit is quite small.
In computer architecture, frequency scaling (also known as frequency ramping) is the technique of increasing a processor's frequency so as to enhance the performance of the system containing the processor in question. Frequency ramping was the dominant force in commodity processor performance increases from the mid-1980s until roughly the end ...
The XOP (eXtended Operations [1]) instruction set, announced by AMD on May 1, 2009, is an extension to the 128-bit SSE core instructions in the x86 and AMD64 instruction set for the Bulldozer processor core, which was released on October 12, 2011. [2]
Some Intel processors have provisions to reduce the Turbo Boost frequency limit when such instructions are being executed. This reduction happens even if the CPU hasn't reached its thermal and power consumption limits. On Skylake and its derivatives, the throttling is divided into three levels: [66] [67] L0 (100%): The normal turbo boost limit.
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.
Maximum size (in bytes) of XSAVE save area for the set of state-components currently set in XCR0. Maximum size (in bytes) of XSAVE save area if all state-components supported by XCR0 on this CPU were enabled at the same time. 64-bit bitmap of state-components supported by XCR0 on this CPU.
Establishing that a computer is frequently CPU-bound implies that upgrading the CPU or optimizing code will improve the overall computer performance. With the advent of multiple buses, parallel processing, multiprogramming , preemptive scheduling, advanced graphics cards , advanced sound cards and generally, more decentralized loads, it became ...
Modified frequency modulation (MFM) is a run-length limited (RLL) line code [1] used to encode data on most floppy disks and some hard disk drives. It was first introduced on hard disks in 1970 with the IBM 3330 and then in floppy disk drives beginning with the IBM 53FD in 1976.