enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Philadelphia rod - Wikipedia

    en.wikipedia.org/wiki/Philadelphia_rod

    The rod is used in levelling procedures to determine elevations and is read using a level. A Philadelphia rod consists of two sliding sections graduated in hundredths of a foot. On the front of the rod the graduation increasing from zero at the bottom. On the back of the rod the graduation decrease from 13.09 ft at the bottom to 7 ft.

  3. Level staff - Wikipedia

    en.wikipedia.org/wiki/Level_staff

    The metric rod has major numbered graduations in meters and tenths of meters (e.g. 18 is 1.8 m - there is a tiny decimal point between the numbers). Between the major marks are either a pattern of squares and spaces in different colours or an E shape (or its mirror image) with horizontal components and spaces between of equal size.

  4. Stadia mark - Wikipedia

    en.wikipedia.org/wiki/Stadia_mark

    Stadia marks on a crosshair while viewing a metric levelling rod. The top mark is at 1.500 m and the lower is at 1.345 m. The difference between the rod readings is 0.155 m, yielding a distance to the rod of 15.5 m. A typical surveyor's instrument reticle has two pairs of stadia marks. One pair are on the horizontal centreline and the other on ...

  5. How To Write Numbers in Words on a Check - AOL

    www.aol.com/finance/write-numbers-words-check...

    That would make $1,200 look like “One thousand, two hundred and 00/100.” ... On the row beneath “Pay to the order of,” write the payment amount in words.

  6. Scale ruler - Wikipedia

    en.wikipedia.org/wiki/Scale_ruler

    A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.

  7. Engineering tolerance - Wikipedia

    en.wikipedia.org/wiki/Engineering_tolerance

    The standard (size) tolerances are divided into two categories: hole and shaft. They are labelled with a letter (capitals for holes and lowercase for shafts) and a number. For example: H7 (hole, tapped hole, or nut) and h7 (shaft or bolt). H7/h6 is a very common standard tolerance which gives a tight fit.

  8. Measuring rod - Wikipedia

    en.wikipedia.org/wiki/Measuring_rod

    A measuring rod is a tool used to physically measure lengths and survey areas of various sizes. Most measuring rods are round or square sectioned; however, they can also be flat boards. Some have markings at regular intervals. It is likely that the measuring rod was used before the line, chain or steel tapes used in modern measurement. [1]

  9. Reading rod and gun club splits $1 million donation ... - AOL

    www.aol.com/sports/reading-rod-gun-club-splits...

    Aug. 2—Decades of doing its own groundskeeping and maintenance work and selling cheap draft beers has allowed the Northend Rod and Gun Club in Reading to save up quite a bit of money, which this ...

  1. Related searches how to read a grade rod in tenths order and make a payment to two thousand

    philadelphia rod grade chartphiladelphia rod readings