Search results
Results from the WOW.Com Content Network
The SLAP design incorporates a polymer sabot, which allows for the use of a tungsten penetrator projectile of a lesser diameter than the original bore.By using the casing of a large cartridge with a lightweight projectile, the velocity of the projectile is greatly increased and the sectional density is improved without requiring a (potentially dangerous) increase in chamber pressure.
Similarly to SLAP rounds (saboted light armor penetrator) which get their armor-piercing ability from the propulsion of a 7.62 mm tungsten heavy alloy bullet from a 12.7 mm barrel (.50 caliber) using a sabot with much more energy than is usually possible from a 7.62 mm round, HEIAP munitions utilize a similar theory with an added explosive ...
The sabot component in projectile design is the relatively thin, tough and deformable seal known as a driving band or obturation ring needed to trap propellant gases behind a projectile, and also keep the projectile centered in the barrel, when the outer shell of the projectile is only slightly smaller in diameter than the caliber of the barrel ...
Armour piercing discarding sabot munitions were developed to increase penetrating performance of anti-tank projectiles by generating higher impact velocity.A larger projectile would require a completely new weapon system, but increasing velocity faced the limitation that steel armour-piercing (AP) projectiles shattered at velocities above about 850 m/s when uncapped.
As a muzzleloader, the rifle is not considered a firearm under the Gun Control Act of 1968; [2] and the integrated suppressor is exempt from the US National Firearms Act because it is permanently attached to the rifle. [3] When fired, the rifle has a report of 139.9 decibels. [1] The firearm does not have iron sights, so requires a telescopic ...
Sub-caliber armour-piercing discarding sabot projectile. Here seen with and without its sabot as well as its internal tungsten core. The most traditional way to fire sub-caliber ammunition is to fit the projectile with an expendable sabot. The sabot is a device which fills out the missing caliber when the projectile is fired and then leaves the ...
Muzzleloading artillery evolved across a wide range of styles, beginning with the bombard, and evolving into culverins, falconets, sakers, demi-cannon, rifled muzzle-loaders, Parrott rifles, and many other styles. Handcannons are excepted from this list because they are hand-held and typically of small caliber.
The lightweight 16-in/50 Mark 7 was designed to resolve this conflict. These guns were 50 calibers long, 50 times their 16-inch (406 mm) bore diameter with barrels 66.7 ft (20.3 m) long, from chamber to muzzle. Each gun weighed about 239,000 lb (108 t) without the breech, and 267,900 lb (121.5 t) with the breech. [1]