Search results
Results from the WOW.Com Content Network
Most importantly, the maximum lift-to-drag ratio is independent of the weight of the aircraft, the area of the wing, or the wing loading. It can be shown that two main drivers of maximum lift-to-drag ratio for a fixed wing aircraft are wingspan and total wetted area. One method for estimating the zero-lift drag coefficient of an aircraft is the ...
Drag and lift coefficients for the NACA 63 3 618 airfoil. Full curves are lift, dashed drag; red curves have R e = 3·10 6, blue 9·10 6. Coefficients of lift and drag against angle of attack. Curve showing induced drag, parasitic drag and total drag as a function of airspeed. Drag curve for the NACA 63 3 618 airfoil, colour-coded as opposite plot.
The power is equal to the drag force times velocity. For aircraft in cruise flight the lift is equal to the weight (L=mg) and the engine thrust is equal to the drag (T=D). Hence, ϵ = P / ( m g v ) = D / L = 1 / f {\displaystyle \epsilon =P/(mgv)=D/L=1/f} , with f=L/D the lift-to-drag ratio , so the specific resistance of airplanes is roughly ...
L/DMAX occurs at minimum Total Drag (e.g. Parasite plus Induced) Coefficients of Drag and Lift vs Angle of Attack. Stall speed corresponds to the Angle of Attack at the Maximum Coefficient of Lift. The lift-to-drag ratio, or L/D ratio, is the amount of lift generated by a wing or vehicle, divided by the drag it creates by moving through the air ...
The logarithmic term with weight ratios is replaced by the direct ratio between / = where is the energy per mass of the battery (e.g. 150-200 Wh/kg for Li-ion batteries), the total efficiency (typically 0.7-0.8 for batteries, motor, gearbox and propeller), / lift over drag (typically around 18), and the weight ratio / typically around 0.3.
In reference to the above diagrams relating lift and drag, Garrett explains that for a maximum speed made good to windward, the sail must be trimmed to an angle of attack that is greater than the maximum lift/drag ratio (more lift), while the hull is operated in a manner that is lower than its maximum lift/drag ratio (more drag). [33]
Clark Y is the name of a particular airfoil profile, widely used in general purpose aircraft designs, and much studied in aerodynamics over the years. The profile was designed in 1922 by Virginius E. Clark using thickness distribution of the German-developed Goettingen 398 airfoil. [1]
It is also useful to show the relationship between section lift coefficient and drag coefficient. The section lift coefficient is based on two-dimensional flow over a wing of infinite span and non-varying cross-section so the lift is independent of spanwise effects and is defined in terms of ′, the lift force per unit span of the wing. The ...