Search results
Results from the WOW.Com Content Network
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
The Double Tap achieves 2,825 ft/s (861 m/s) and 4,700 ft⋅lb (6,400 J) with a 270-grain Barnes TSX from a 23-inch barrel Ruger 77 African. The .375 Ruger's greater case capacity, and the "short fat" cartridge efficiency lead to increases in the neighborhood of 150 to 200 fps over the .375 H&H Magnum cartridge.
The .376 Steyr (9.5x59mmRB) cartridge is a rebated rim rifle cartridge jointly developed by Hornady and Steyr for use in the Steyr Scout rifle.. Introduced in 1999, it is based on the 9.3×64mm Brenneke case, necked up to accept a 0.375-inch (9.5 mm) diameter bullet.
The vehicle has a welded steel hull, ranging in thickness from 0.375 inches (0.95 cm) on the top to 1 inch (2.49 cm) thick on the belly, with the median thickness being 0.625 inches (1.59 cm). It retained the rather slab sided appearance and blunt nose of its predecessor.
The bottom of the hull front has an additional 0.375 inch (9.5 mm) thick steel applique plate, primarily intended to protect against mines. Both sides of the vehicle have an additional 0.5 inch (12.7 mm) of high hardness steel armor consisting of two quarter-inch applique armor plates spaced 1 inch apart from each other, the first spaced 3.5 ...
The .375 H&H Magnum, also known as .375 Holland & Holland Magnum, is a medium-bore rifle cartridge introduced in 1912 by London based gunmaker Holland & Holland. [2] The .375 H&H cartridge featured a belt to ensure the correct headspace, which otherwise might be unreliable, given the narrow shoulder of the cartridge case. [3]
A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [ 27 ] [ 33 ] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry.