Search results
Results from the WOW.Com Content Network
Signal-to-noise ratio (SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. SNR is defined as the ratio of signal power to noise power , often expressed in decibels .
The ratio of (a) total received power, i.e., the signal to (b) the noise-plus-distortion power. This is modeled by the equation above. [2] The ratio of (a) the power of a test signal, i.e. a sine wave, to (b) the residual received power, i.e. noise-plus-distortion power. With this definition, it is possible to have a SINAD level less than one.
Traditionally, SNR is defined to be the ratio of the average signal value to the standard deviation of the signal : [2] [3] = when the signal is an optical intensity, or as the square of this value if the signal and noise are viewed as amplitudes (field quantities).
Sensitivity second definition: the minimum magnitude of input signal required to produce an output signal with a specified signal-to-noise ratio of an instrument or sensor. Examples of the use of this definition are given in the sections below on receivers and electronic sensors.
In telecommunications, the carrier-to-noise ratio, often written CNR or C/N, is the signal-to-noise ratio (SNR) of a modulated signal. The term is used to distinguish the CNR of the radio frequency passband signal from the SNR of an analog base band message signal after demodulation .
Channel noise level, some measure of noise in a communication channel; Noise-equivalent target, intensity of a target when the signal-to-noise level is 1 [2] Equivalent noise resistance, a measure of noise based on equivalent resistor; Carrier-to-receiver noise density, ratio of received carrier power to receiver noise; Carrier-to-noise-density ...
[5] [6] Acceptable values for wireless transmission quality loss are considered to be about 20 dB to 25 dB. [7] [8] In the absence of noise, the two images I and K are identical, and thus the MSE is zero. In this case the PSNR is infinite (or undefined, see Division by zero). [9]
An important consequence of this formula is that the overall noise figure of a radio receiver is primarily established by the noise figure of its first amplifying stage. Subsequent stages have a diminishing effect on signal-to-noise ratio. For this reason, the first stage amplifier in a receiver is often called the low-noise amplifier (LNA ...