Search results
Results from the WOW.Com Content Network
ipconfig in Mac OS X serves as a wrapper to the IPConfiguration agent, and can be used to control the Bootstrap Protocol and DHCP client from the command-line interface. [8] For example, you can release and renew an IP address if it happened to be assigned incorrectly by the DHCP server during the automated assignment process. [9]
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
ipconfig, a command similar to ifconfig, comes with Microsoft operating-systems based on the Windows NT kernel. ipconfig also controls the Windows DHCP client. In macOS, the ifconfig command functions as a wrapper to the IPConfiguration agent, and can control the BootP and DHCP clients from the command-line. Use of ifconfig to modify network ...
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
Mageia has had full support for IPv6 only and IPv4 + IPv6 since Mageia 7, as well as continuing to support IPv4 only systems. [15] macOS: Mac OS X 10.7 (Lion) Yes Yes Yes [16] Yes [17] Versions 10.7 through 10.10 often prefer IPv4 even when working IPv6 connectivity is available. [18]
A solicited-node multicast address is an IPv6 multicast address used by the Neighbor Discovery Protocol to determine the link layer address associated with a given IPv6 address, which is also used to check if an address is already being used by the local-link or not, through a process called DAD (Duplicate Address Detection). The solicited-node ...
For IPv6, Path MTU Discovery works by initially assuming the path MTU is the same as the MTU on the link layer interface where the traffic originates. Then, similar to IPv4, any device along the path whose MTU is smaller than the packet will drop the packet and send back an ICMPv6 Packet Too Big (Type 2) message containing its MTU, allowing the ...