Search results
Results from the WOW.Com Content Network
By far the most popular FCS algorithm is a cyclic redundancy check (CRC), used in Ethernet and other IEEE 802 protocols with 32 bits, in X.25 with 16 or 32 bits, in HDLC with 16 or 32 bits, in Frame Relay with 16 bits, [3] in Point-to-Point Protocol (PPP) with 16 or 32 bits, and in other data link layer protocols.
A frame is a series of bits generally composed of frame synchronization bits, the packet payload, and a frame check sequence. Examples are Ethernet frames, Point-to-Point Protocol (PPP) frames, Fibre Channel frames, and V.42 modem frames. Often, frames of several different sizes are nested inside each other.
This frame may cause a collision at the remote end which cannot be detected by the transmitter, so the frame is not resent on the physical layer. Due to interference on the medium, its data is corrupted and frame check sequence fails, requiring recovery at a higher layer, if possible. [citation needed]
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).
Diagram of an ethernet frame. File usage. The following 4 pages use this file: Ethernet frame; Frame check sequence; Jumbo frame; User:Mikm/Gallery; Global file usage.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
In telecommunications, frame synchronization or framing is the process by which, while receiving a stream of fixed-length frames, the receiver identifies the frame boundaries, permitting the data bits within the frame to be extracted for decoding or retransmission.
Any unique sequence which will not be interpreted by the secondaries will do, but the conventional one is a single all-zero byte. [9]: 44 This is a "runt frame" with an address of 0 (reserved, unused) and no control field or frame check sequence. (Secondaries capable of full-duplex operation also interpret this as a "shut-off sequence", forcing ...