enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Jump wire - Wikipedia

   en.wikipedia.org/wiki/Jump_wire

   Stranded 22AWG jump wires with solid tips. A jump wire (also known as jumper, jumper wire, DuPont wire) is an electrical wire, or group of them in a cable, with a connector or pin at each end (or sometimes without them – simply "tinned"), which is normally used to interconnect the components of a breadboard or other prototype or test circuit, internally or with other equipment or components ...

3. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   Wire size Features Notes Datasheet RCY [23] 2.50 ... Used in some RGB LED decorative light strips. JST SM: Soldering

4. Jumper cable (disambiguation) - Wikipedia

   en.wikipedia.org/wiki/Jumper_cable_(disambiguation)

   Jumper cable may also refer to: Jump wire, a short electrical wire with a solid tip at each end used to interconnect the components in a breadboard; Jumper cable (vehicle), a pair of electrical cables used to jump start a vehicle; Jumper Cable, the 33rd book in the Xanth series by Piers Anthony

5. Jumper (computing) - Wikipedia

   en.wikipedia.org/wiki/Jumper_(computing)

   These wires are called wire bridges or jumpers, but unlike jumpers used for configuration settings, they are intended to permanently connect the points in question. They are used to solve layout issues of the printed wiring, providing connections that would otherwise require awkward (or in some cases, impossible) routing of the conductive traces.

6. Zero-ohm link - Wikipedia

   en.wikipedia.org/wiki/Zero-ohm_link

   A zero-ohm link or zero-ohm resistor is a wire link packaged in the same physical package format as a resistor. It is used to connect traces on a printed circuit board (PCB). This format allows it to be placed on the circuit board using the same automated equipment used to place other resistors, instead of requiring a separate machine to ...

7. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   Diode (all types, including LED), thyristor "D" is preferred for various types of diodes DL: Delay line: DN: Diode network: may be simplified to "D" for diode DS: Display, general light source, lamp, signal light: F: Fuse: FB: Ferrite bead: sometimes changed to "L" for inductor, though "E" was used in the currently inactive standard IEEE 315 ...

8. Pin header - Wikipedia

   en.wikipedia.org/wiki/Pin_header

   1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector.A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1]

9. Bonding jumper - Wikipedia

   en.wikipedia.org/wiki/Bonding_jumper

   Bonding jumpers may be installed wherever metal parts are free to move on a hinge or bearing. This is done for electrical safety grounding, static electricity protection, and may also be useful for control of electromagnetic interference. For example, a control panel door may have a bonding jumper across the hinges so that the metal door is ...