Search results
Results from the WOW.Com Content Network
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
Although the IAC is supposed to last the vehicle's lifetime, various reasons may cause it to fail/malfunction prematurely. The most common failure mode is partial/complete jamming of the actuator (due to dirt/dust or even oil) where it cannot be smoothly controlled. The result is an engine that fails to maintain idle RPM and frequently stalls.
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
Stuck throttle (unrelated to pedal position) [12] [13] Shorting of tin whiskers [14] [15] Diesel engine runaway: Diesel engine power is governed by the amount of fuel supplied. Excessive pressure in the crankcase can force mist of engine oil into the intake manifold, which can be burned in the same fashion as Diesel fuel, thus causing runaway.
A phosphate coat is necessary to protect the body against corrosion effects and prepares the surface for the E-Coat. The body is dipped into the Electro-Coat Paint Operation (ELPO/E-Coat), then a high voltage is applied. The body works as a cathode and the paint as an anode sticking on the body surface. It is an eco-friendly painting process.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Seam sealing was already performed manually successfully for preventing perforation corrosion in the 1980s. [1] Today used in the OEM automotive industry primarily for the purpose of seals against air leaks and to waterproof sheetmetal overlaps that occur in the assembly of a vehicle.
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.