Search results
Results from the WOW.Com Content Network
Electric bells are typically designed to operate on low voltages of from 5 to 24 V AC or DC. Before widespread distribution of electric power, bells were necessarily powered by batteries, either wet-cell or dry-cell type. [2] Bells used in early telephone systems derived current by a magneto generator cranked by the subscriber.
Rooms were fitted with bell pulls or levers which a household member could pull. A system of wires connected the pull to a bell in a service area, in stairwells or outside servants' rooms. [1] The bells were fixed to a board and each bell was individually labelled so servants could see which room requested service. [1] Bells hung from coiled ...
The system of operation of the Franklin clock considers that the electrostatic force generated by an electric field is used to move the pendulums that strike two metal bells. [8] [9] The Franklin bells uses a metal rod as a lightning rod to attract current. One bell is connected to the lightning rod and the other bell is connected to the ground.
On a circuit diagram, the symbols for components are labelled with a descriptor or reference designator matching that on the list of parts. For example, C1 is the first capacitor, L1 is the first inductor, Q1 is the first transistor, and R1 is the first resistor. Often the value or type designation of the component is given on the diagram ...
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
Ringing is a telecommunication signal that causes a bell or other device to alert a telephone subscriber to an incoming telephone call.Historically, this entailed sending a high-voltage alternating current over the telephone line to a customer station which contained an electromagnetic bell.
Early devices were based on an electromechanical system identical to an electric bell without the metal gong. Similarly, a relay may be connected to interrupt its own actuating current, causing the contacts to buzz (the contacts buzz at line frequency if powered by alternating current) Often these units were anchored to a wall or ceiling to use it as a sounding board.
A typical volume of Bell System Practices from the 1970s. The Bell System Practices (BSPs) is a compilation of technical publications which describes the best methods of engineering, constructing, installing, and maintaining the telephone plant of the Bell System under direction of AT&T and Bell Telephone Laboratories. [1]