Search results
Results from the WOW.Com Content Network
A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.
Drill chucks mounted by Jacobs tapers onto arbors with Morse tapers for the spindle. Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut.
Modern metal lathe A watchmaker using a lathe to prepare a component cut from copper for a watch. A lathe (/ l eɪ ð /) is a machine tool that rotates a workpiece about an axis of rotation to perform various operations such as cutting, sanding, knurling, drilling, deformation, facing, threading and turning, with tools that are applied to the workpiece to create an object with symmetry about ...
For example, a workpiece may require a specific outside diameter. A lathe is a machine tool that can create that diameter by rotating a metal workpiece so that a cutting tool can cut metal away, creating a smooth, round surface matching the required diameter and surface finish. A drill can remove the metal in the shape of a cylindrical hole.
Dead center (the conical piece) mounted in the spindle of a lathe and being used to support a workpiece being driven by a carrier setup. A lathe center, often shortened to center, is a tool that has been ground to a point to accurately position a workpiece on an axis. They usually have an included angle of 60°, but in heavy machining ...
These rigid machine tools remove material from a rotating workpiece via the (typically linear) movements of various cutting tools, such as tool bits and drill bits. Metal lathes can vary greatly, but the most common design is known as the universal lathe or parallel lathe.
When a cutting tool such as a drill bit or reamer is used, the feed is done with this leadscrew. The extendible portion of the tailstock is called the barrel, and usually has a Morse taper mount in the end of it to secure the drill or reamer. If the work is heavy, the drill may be further secured from turning with a lathe dog as shown in the photo.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.