Search results
Results from the WOW.Com Content Network
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
The Intel 8085 ("eighty-eighty-five") is an 8-bit microprocessor produced by Intel and introduced in March 1976. [2] It is the last 8-bit microprocessor developed by Intel. It is software-binary compatible with the more-famous Intel 8080 with only two minor instructions added to support its added interrupt and serial input/output features.
The 8259 may be configured to work with an 8080/8085 or an 8086/8088. On the 8086/8088, the interrupt controller will provide an interrupt number on the data bus when an interrupt occurs. The interrupt cycle of the 8080/8085 will issue three bytes on the data bus (corresponding to a CALL instruction in the 8080/8085 instruction set).
The Intel 8086 trap flag and type-1 interrupt response make it quite easy to implement a single-step feature in an 8086-based system. If the trap flag is set, the 8086 will automatically do a type-1 interrupt after each instruction executes. When the 8086 does a type-1 interrupt, it pushes the flag register on the stack.
In a computer, an interrupt request (or IRQ) is a hardware signal sent to the processor that temporarily stops a running program and allows a special program, an interrupt handler, to run instead. Hardware interrupts are used to handle events such as receiving data from a modem or network card , key presses, or mouse movements.
A software interrupt is a specific variety of the general concept of an interrupt. An interrupt is a mechanism by which the CPU can be directed to stop executing the main-line program and immediately execute a special program, called an Interrupt Service Routine (ISR), instead. Once the ISR finishes, the CPU continues with the main program.
INT is an assembly language instruction for x86 processors that generates a software interrupt. It takes the interrupt number formatted as a byte value. [1] When written in assembly language, the instruction is written like this: INT X. where X is the software interrupt that should be generated (0-255).
The interrupt descriptor table (IDT) is a data structure used by the x86 architecture to implement an interrupt vector table. The IDT is used by the processor to determine the memory addresses of the handlers to be executed on interrupts and exceptions .