Ads
related to: high efficiency furnace exhaust cap for rain gear pump
Search results
Results from the WOW.Com Content Network
Condensate pumps may be used to pump the condensate produced from latent water vapor in any of the following gas mixtures: Conditioned (cooled or heated) building air; Refrigerated air in cooling and freezing systems; Steam in heat exchangers and radiators; The exhaust stream of very-high-efficiency furnaces
High-efficiency condensing furnaces condense the water vapor (one of the by-products of gas combustion) and extract the latent heat to pre-heat the incoming furnace airflow, using a second heat exchanger. [2] This increases the efficiency (energy delivered into the building vs. heating value of gas purchased) to over 90%.
A run-around coil installation, serving air handling units on the roof of an office building. A run-around coil is a type of energy recovery heat exchanger most often positioned within the supply and exhaust air streams of an air handling system, or in the exhaust gases of an industrial process, to recover the heat energy.
The idea is that as hot exhaust gases flow through the checkerwork, they give up heat to the bricks. The airflow is then reversed, so that the hot bricks heat up the incoming combustion air and fuel. For a glass-melting furnace, a regenerator sits on either side of the furnace, often forming an integral whole.
Methods of removing sulfur dioxide from boiler and furnace exhaust gases have been studied for over 150 years. Early ideas for flue gas desulfurization were established in England around 1850. With the construction of large-scale power plants in England in the 1920s, the problems associated with large volumes of SO 2 from a single site began to ...
Diagramatic operation of a thermal wheel Ljungström Air Preheater by Swedish engineer Fredrik Ljungström (1875–1964). A thermal wheel, also known as a rotary heat exchanger, or rotary air-to-air enthalpy wheel, energy recovery wheel, or heat recovery wheel, is a type of energy recovery heat exchanger positioned within the supply and exhaust air streams of air-handling units or rooftop ...
A flue is a duct, pipe, or opening in a chimney for conveying exhaust gases from a fireplace, furnace, water heater, boiler, or generator to the outdoors. Historically the term flue meant the chimney itself. [1] In the United States, they are also known as vents for boilers and as breeching for water heaters and modern
A recuperator is a special purpose counter-flow energy recovery heat exchanger positioned within the supply and exhaust air streams of an air handling system, or in the exhaust gases of an industrial process, in order to recover the waste heat. Generally, they are used to extract heat from the exhaust and use it to preheat air entering the ...
Ads
related to: high efficiency furnace exhaust cap for rain gear pump