Search results
Results from the WOW.Com Content Network
Architects, engineers and builders found it difficult to compare rated capacities and to use fully the economies of steel joist construction. Gable steel joists being erected. Members of the industry began to organize the institute, and in 1928 the first standard specifications were adopted, followed in 1929 by the first load table. The joists ...
Structural ironworkers also erect joist girders, bar joists, and trusses, and also install metal decking. When one bullpin is inadequate, the Ratliff Technique [citation needed] may be utilized in order to force a bullpin to align itself straight with a hole, by driving another bullpin or driftpin between a steel member, and the first bullpin.
Plate girder, formed by welding (or occasionally bolting or riveting) plates. I-beams are commonly made of structural steel but may also be formed from aluminium or other materials. A common type of I-beam is the rolled steel joist (RSJ), sometimes incorrectly rendered as reinforced steel joist.
A girder (/ ˈ ɡ ɜːr d ər /) is a beam used in construction. [1] It is the main horizontal support of a structure which supports smaller beams. Girders often have an I-beam cross section composed of two load-bearing flanges separated by a stabilizing web, but may also have a box shape, Z shape, or other forms. Girders are commonly used to ...
A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).
A rolled steel girder is a girder that has been fabricated by rolling a blank cylinder of steel through a series of dies to create the desired shape. These create standardized I-beam and wide flange beam [7] shapes up to 100 feet in length. A plate girder is a girder that has been fabricated by welding plates together to create the desired ...
In a plate girder bridge, the plate girders are typically I-beams made up from separate structural steel plates (rather than rolled as a single cross-section), which are welded or, in older bridges, bolted or riveted together to form the vertical web and horizontal flanges of the beam. In some cases, the plate girders may be formed in a Z-shape ...
An 1883 article from The American Architect and Building News compares three alternatives in a hypothetical railway station "in which the second story is devoted to offices, and where we must use girders to support the second floor of 25-foot span, and not less than 12 feet on centres if we can avoid it.