enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Threaded rod - Wikipedia

   en.wikipedia.org/wiki/Threaded_rod

   A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the rod. [1] They are designed to be used in tension. [2] Threaded rod in bar stock form is often called all-thread (ATR); other names include fully-threaded rod, redi-rod, continuously-threaded rod ...

3. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

4. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   Royal Microscopical Society (RMS) thread, also known as society thread, is a special 0.8-inch diameter × 36 thread-per-inch (TPI) Whitworth thread form used for microscope objective lenses. Microphone stands: 5 ⁄ 8-inch 27 threads per inch (TPI) Unified Special thread (UNS, USA and the rest of the world)

5. Strut channel - Wikipedia

   en.wikipedia.org/wiki/Strut_channel

   Punched channel has round holes, large enough for an M16 or 5/8 inch threaded steel rod or bolts, punched in the top of the channel at regular 48 mm (1 7/8 inch) centers. Half-slot channel has short, rounded end rectangular slots punched out on 50 mm (2 inch) centers. Slot channel has longer slots on 100 mm (4 inch) centers.

6. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The sealants, where used, are typically thread seal tape thread sealant or a thread seal paste pipe dope (sometimes similar in composition to plumber's putty). Because the thread body is tapered (0.75 in/ft or 62.5 mm/m), a larger diameter keeps compressing into a smaller diameter and finally forms a seal (no clearance remains between the ...

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.