Search results
Results from the WOW.Com Content Network
Underfloor heating and cooling is a form of central heating and cooling that achieves indoor climate control for thermal comfort using hydronic or electrical heating elements embedded in a floor. Heating is achieved by conduction, radiation and convection. Use of underfloor heating dates back to the Neoglacial and Neolithic periods.
Hypocaust under the floor in a Roman villa in Vieux-la-Romaine, near Caen, France. A hypocaust (Latin: hypocaustum) is a system of central heating in a building that produces and circulates hot air below the floor of a room, and may also warm the walls with a series of pipes through which the hot air passes.
Installation of a double-walled copper-on-copper heat exchanger in a vertical section of the master drain line in a Canadian home (2007) Water heat recycling (also known as drain water heat recovery, waste water heat recovery, greywater heat recovery, [citation needed] or sometimes shower water heat recovery [citation needed]) is the use of a heat exchanger to recover energy and reuse heat ...
Usually, each floor drain is connected to a trap, to prevent sewer gases from escaping into indoors spaces. A floor sink is a type of floor drain primarily used as an indirect waste receptor. It is generally deeper than a standard floor drain and can have a full or partial grate, or no grate as required to accommodate the indirect waste pipes.
PVC closet flange with steel flange, before installation. closet flange (also known as a toilet flange) is a pipe fitting (specifically, a type of flange) that both mounts a toilet to the floor and connects the closet bend to a drain pipe. The name comes from the term "water closet", the traditional name for a toilet.
The ground floor with a slab on grade has less temperature rise compared to middle and top floors, and an increase of the supply air temperature causes a decrease in the temperature rise. The temperature rise is not significantly affected by the perimeter zone orientation, the internal heat gain and the window-to-wall ratio. [16]
An ordinary electric shower often but not always has three heat settings: high (5.5 kW), low (2.5 kW), or cold (0 W) to use when a central heater system is available or in hot seasons. Higher power (up to 7.5 KW) and lower power (up to 3.2 KW) versions are also made, as well as versions with 4 heat settings or a variable heat setting.
Baseboard convectors are designed to heat the air in the room using convection to transfer heat from the radiators to the surrounding air. [4] They do this by drawing cool air in at the bottom, warming the air as it passes over the radiator fins, and discharging the heated air at the top. This sets up convective loops of air movement within a room.