Search results
Results from the WOW.Com Content Network
A crossflow head gives better performance than a Reverse-flow cylinder head (though not as good as a uniflow), but the popular explanation put forward for this — that the gases do not have to change direction and hence are moved into and out of the cylinder more efficiently — is a simplification since there is no continuous flow because of valve opening and closing.
The flow in manifolds is extensively encountered in many industrial processes when it is necessary to distribute a large fluid stream into several parallel streams, or to collect them into one discharge stream, such as in fuel cells, heat exchangers, radial flow reactors, hydronics, fire protection, and irrigation. Manifolds can usually be ...
The intake manifold connects to the air filter directly, or to a carburetor when one is present, which is then connected to the air filter. It distributes the air incoming from these devices to the individual cylinders. The exhaust manifold is the first component in the exhaust system. It collects the exhaust gases from the cylinders and drives ...
Types of manifolds in engineering include: Exhaust manifold An engine part that collects the exhaust gases from multiple cylinders into one pipe. Also known as headers. Hydraulic manifold A component used to regulate fluid flow in a hydraulic system, thus controlling the transfer of power between actuators and pumps Inlet manifold (or "intake ...
The intake manifold vacuum, with wide open throttle, is lower in these conditions, which causes the PCV valve to open and the crankcase gases flow to the intake system. [13] The greater flow rate of intake air during these conditions means that a greater quantity of blow-by gases can be added to the intake system without compromising the ...
In the custom-built manifold, the runners to the intake ports on the cylinder head are much wider and more gently tapered. This difference improves the volumetric efficiency of the engine's fuel/air intake. The design and orientation of the intake manifold is a major factor in the volumetric efficiency of an engine. Abrupt contour changes ...
By opening the intake valve early, some of the inert/combusted exhaust gas will back flow out of the cylinder via the intake valve, where it cools momentarily in the intake manifold. This inert gas then fills the cylinder in the subsequent intake stroke, which aids in controlling the temperature of the cylinder and nitric oxide emissions.
The way they do this is during a deceleration of the vehicle when there is low absolute pressure in the intake manifold (i.e., a high vacuum present in the intake manifold relative to the outside air) the powertrain control module (PCM) will open the EGR valve and then monitor the MAP sensor's values. If the EGR is functioning properly, the ...