Ad
related to: greenstar boiler not firing up fans in winter and summer colorsheatingandairtoday.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Since the final exhaust from a condensing boiler has a lower temperature than the exhaust from an atmospheric boiler 38 °C (100 °F) vs. 204 °C (400 °F) a mechanical fan is always required to expel it, with the additional benefit of allowing the use of low-temperature exhaust piping (typically PVC in domestic applications) without insulation ...
By comparison, most modern "warm air" furnaces typically use a fan to circulate air to the rooms of house and pull cooler air back to the furnace for reheating; this is called forced-air heat. Because the fan easily overcomes the resistance of the ductwork, the arrangement of ducts can be far more flexible than the octopus of old. In American ...
A pressuretrol is a control used to control a steam boiler, by setting when the boiler should begin and end firing based on steam pressure. The pressuretrol is ...
The English writer Hugh Plat proposed a steam-based central heating system for a greenhouse in 1594, although this was an isolated occurrence and was not followed up until the 18th century. Colonel Coke devised a system of pipes that would carry steam around the house from a central boiler, but it was James Watt the Scottish inventor who was ...
The boiler will also fire (regardless of thermostat state) when the boiler water temperature goes below a range around the low limit, ensuring that the boiler water temperature remains above a certain point. The low limit is intended for tankless domestic hot water; it ensures that boiler water is always warm enough to heat the domestic hot water.
In a water boiler, draft is the difference between atmospheric pressure and the pressure existing in the furnace or flue gas passage. [1] Draft can also be referred to as the difference in pressure in the combustion chamber area which results in the motion of the flue gases and the air flow. [2]
The thermal expansion is from top to bottom and with the usage of grate firing the grate firing the thermal expansion difference is minimised there by manifesting the sealing between grate and the boiler. The shorter path of water supply to the riser tubes leads to faster and more reliable operation on different loads and a quick start up. [1]
Development of recovery boiler main steam pressure and temperature was rapid at the beginning. By 1955, not even 20 years from birth of recovery boiler highest steam pressures were 10.0 MPa and 480 °C. The pressures and temperatures used then backed downward somewhat due to safety. [14] By 1980 there were about 700 recovery boilers in the ...
Ad
related to: greenstar boiler not firing up fans in winter and summer colorsheatingandairtoday.com has been visited by 10K+ users in the past month