Search results
Results from the WOW.Com Content Network
The bridge has three ports. A is connected to bridge port 1, B is connected to bridge port 2, C is connected to bridge port 3. A sends a frame addressed to B to the bridge. The bridge examines the source address of the frame and creates an address and port number entry for host A in its forwarding table. The bridge examines the destination ...
Switching loops can cause misleading entries in a switch's media access control (MAC) database and can cause endless unicast frames to be broadcast throughout the network. A loop can make a switch receive the same broadcast frames on two different ports, and alternatingly associate the sending MAC address with the one or the other port.
Router software requires updating to stay secure, this comparison provides an overview of third party options. Embedded. General. Project Parent project Software ...
In contrast to an Ethernet hub, there is a separate collision domain on each switch port. This allows computers to have dedicated bandwidth on point-to-point connections to the network and also to run in full-duplex mode. Full-duplex mode has only one transmitter and one receiver per collision domain, making collisions impossible.
Nominally, only broadcast frames will be received by all other nodes. Collisions are localized to the physical-layer network segment they occur on. Thus, the broadcast domain is the entire inter-connected layer-2 network, and the segments connected to each switch or bridge port are each a collision domain. To clarify; repeaters do not divide ...
A bridge router or brouter [1] is a network device that works as a bridge and as a router. The brouter routes packets for known protocols and simply forwards all other packets as a bridge would. [2] Brouters operate at both the network layer for routable protocols and at the data link layer for non-routable protocols. As networks continue to ...
Dense mode multicast is one mode that multicast can use to construct a tree for sending packets to the multicast subscribers. It is an alternative to sparse mode. The basic assumption behind dense mode is that the multicast packet stream has receivers at most locations. Sparse mode assumes relatively fewer receivers.
A routing bridge or RBridge, also known as a TRILL switch, is a network device that implements the TRILL protocol [1] and should not be confused with BRouters (Bridging Routers). RBridges are compatible with previous IEEE 802.1 customer bridges as well as IPv4 and IPv6 routers and end nodes.