Search results
Results from the WOW.Com Content Network
Cascading can be implemented in terms of chaining by having the methods return the target object (receiver, this, self).However, this requires that the method be implemented this way already – or the original object be wrapped in another object that does this – and that the method not return some other, potentially useful value (or nothing if that would be more appropriate, as in setters).
The bridge has three ports. A is connected to bridge port 1, B is connected to bridge port 2, C is connected to bridge port 3. A sends a frame addressed to B to the bridge. The bridge examines the source address of the frame and creates an address and port number entry for host A in its forwarding table. The bridge examines the destination ...
Switching loops can cause misleading entries in a switch's media access control (MAC) database and can cause endless unicast frames to be broadcast throughout the network. A loop can make a switch receive the same broadcast frames on two different ports, and alternatingly associate the sending MAC address with the one or the other port.
Cascading can be implemented using method chaining by having the method return the current object itself. Cascading is a key technique in fluent interfaces , and since chaining is widely implemented in object-oriented languages while cascading isn't, this form of "cascading-by-chaining by returning this " is often referred to simply as "chaining".
This is distinct from other "bridge modes" commonly found in combined DSL modems and routers, which turn off the router portion of the DSL modem. In VC Multiplexing (VC-MUX), the hosts agree on the high-level protocol for a given circuit. It has the advantage of not requiring additional information in a packet, which minimises the overhead.
Because the switch only ever buffers 64 bytes of each frame, fragment-free is a faster mode than store-and-forward, but there still exists a risk of forwarding bad frames. [ 7 ] There are certain scenarios that force a cut-through Ethernet switch to buffer the entire frame, acting like a store-and-forward Ethernet switch for that frame:
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
A bridge router or brouter [1] is a network device that works as a bridge and as a router. The brouter routes packets for known protocols and simply forwards all other packets as a bridge would. [2] Brouters operate at both the network layer for routable protocols and at the data link layer for non-routable protocols. As networks continue to ...