Search results
Results from the WOW.Com Content Network
A time-slot interchange (TSI) switch is a network switch that stores data in RAM in one sequence, and reads it out in a different sequence. It uses RAM, a small routing memory and a counter. Like any switch, it has input and output ports. The RAM stores the packets or other data that arrive via its input terminal.
The time to read the first bit of memory from a DRAM without an active row is T RCD + CL. Row Precharge Time T RP: The minimum number of clock cycles required between issuing the precharge command and opening the next row. The time to read the first bit of memory from a DRAM with the wrong row open is T RP + T RCD + CL. Row Active Time T RAS
To refresh one row of the memory array using RAS only refresh (ROR), the following steps must occur: The row address of the row to be refreshed must be applied at the address input pins. RAS must switch from high to low. CAS must remain high. At the end of the required amount of time, RAS must return high.
The maximum random access memory (RAM) installed in any computer system is limited by hardware, software and economic factors. The hardware may have a limited number of address bus bits, limited by the processor package or design of the system. Some of the address space may be shared between RAM, peripherals, and read-only memory.
Non-volatile random-access memory (NVRAM) is random-access memory that retains data without applied power. This is in contrast to dynamic random-access memory (DRAM) and static random-access memory (SRAM), which both maintain data only for as long as power is applied, or forms of sequential-access memory such as magnetic tape, which cannot be randomly accessed but which retains data ...
The ordering, however, depends on the requested address, and the configured burst type option: sequential or interleaved. Typically, a memory controller will require one or the other. When the burst length is one or two, the burst type does not matter. For a burst length of one, the requested word is the only word accessed.
Read–write memory, or RWM, is a type of computer memory that can be easily written to as well as read from using electrical signaling normally associated with running a software, and without any other physical processes.
These new models, with a DDR2 controller, use a different physical socket (known as Socket AM2), so that they will only fit in motherboards designed for the new type of RAM. When the memory controller is not on-die, the same CPU may be installed on a new motherboard, with an updated northbridge to use newer memory.