Ads
related to: fuel injector puller harbor freight motor kits home depot canada kids workshop
Search results
Results from the WOW.Com Content Network
Prior to 1979, the electronics in fuel injection systems used analogue electronics for the control system. The Bosch Motronic multi-point fuel injection system (also amongst the first systems where the ignition system is controlled by the same device as the fuel injection system) was the first mass-produced system to use digital electronics.
Common rail fuel system on a Volvo truck engine. In 1916 Vickers pioneered the use of mechanical common rail systems in G-class submarine engines. For every 90° of rotation, four plunger pumps allowed a constant injection pressure of 3,000 pounds per square inch (210 bar; 21 MPa), with fuel delivery to individual cylinders being shut off by valves in the injector lines. [1]
Harbor Freight Tools, commonly referred to as Harbor Freight, is an American privately held tool and equipment retailer, headquartered in Calabasas, California. It operates a chain of retail stores, as well as an e-commerce business. The company employs over 28,000 people in the United States, [5] and has over 1,500 locations in 48 states. [6] [7]
Injection pump for a 12-cylinder diesel engine. An injection pump is the device that pumps fuel into the cylinders of a diesel engine.Traditionally, the injection pump was driven indirectly from the crankshaft by gears, chains or a toothed belt (often the timing belt) that also drives the camshaft.
Early Lucas electronic diesel unit injector. A unit injector (UI) is a high-pressure integrated direct fuel injection system for diesel engines, combining the injector nozzle and the injection pump in a single component. The plunger pump used is usually driven by a shared camshaft. In a unit injector, the device is typically lubricated and ...
In manifold injection (as well as carburetors and throttle-body fuel injection), fuel can be added to the intake air mixture at any time. However a GDI engine is limited to injecting fuel during the intake and compression phases. This becomes a restriction at high engine speeds (RPM), when the duration of each combustion cycle is shorter.
The non-lifting Nathan 4000 injector used on the Southern Pacific 4294 could push 12,000 US gallons (45,000 L) per hour at 250 psi (17 bar). [11] The lifting injector can operate with negative inlet fluid pressure i.e. fluid lying below the level of the injector. It differs from the non-lifting type mainly in the relative dimensions of the nozzles.
Manifold injection is a mixture formation system for internal combustion engines with external mixture formation. It is commonly used in engines with spark ignition that use petrol as fuel, such as the Otto engine, and the Wankel engine.
Ads
related to: fuel injector puller harbor freight motor kits home depot canada kids workshop