Search results
Results from the WOW.Com Content Network
There are three tables: nat, filter, and mangle. Unless preceded by the option -t, an iptables command concerns the filter table by default. For example, the command iptables -L -v -n, which shows some chains and their rules, is equivalent to iptables -t filter -L -v -n. To show chains of table nat, use the command iptables -t nat -L -v -n
IP-in-IP IP in IP (encapsulation) RFC 2003: 0x05 5 ST Internet Stream Protocol: RFC 1190, RFC 1819: 0x06 6 TCP Transmission Control Protocol: RFC 793: 0x07 7 CBT Core-based trees: RFC 2189: 0x08 8 EGP Exterior Gateway Protocol: RFC 888: 0x09 9 IGP Interior gateway protocol (any private interior gateway, for example Cisco's IGRP) 0x0A 10 BBN-RCC-MON
IP addresses are assigned to a host either dynamically as they join the network, or persistently by configuration of the host hardware or software. Persistent configuration is also known as using a static IP address. In contrast, when a computer's IP address is assigned each time it restarts, this is known as using a dynamic IP address.
The IP address in CIDR notation is always represented according to the standards for IPv4 or IPv6. The address may denote a specific interface address (including a host identifier, such as 10.0.0.1 / 8 ), or it may be the beginning address of an entire network (using a host identifier of 0, as in 10.0.0.0 / 8 or its equivalent 10 / 8 ).
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network Used for local communications within a private network [3] 192.0.0.0/24 192.0.0.0–192.0.0.255 256
The Internet protocol suite, commonly known as TCP/IP, is a framework for organizing the set of communication protocols used in the Internet and similar computer networks according to functional criteria.
The Dynamic Host Configuration Protocol (DHCP) is a network management protocol used on Internet Protocol (IP) networks for automatically assigning IP addresses and other communication parameters to devices connected to the network using a client–server architecture.
The packet is then forwarded to the external network. The NAT device then makes an entry in a translation table containing the internal IP address, original source port, and the translated source port. Subsequent packets from the same internal source IP address and port number are translated to the same external source IP address and port number.