Search results
Results from the WOW.Com Content Network
For example, a USB 2 PCIe host controller card that presents 4 USB "Standard A" connectors typically presents one 4-port EHCI and two 2-port OHCI controllers to system software. When a high-speed USB device is attached to any of the 4 connectors, the device is managed through one of the 4 root hub ports of the EHCI controller.
Open Host Controller Interface (OHCI) [1] is an open standard.. Die shot of a VIA VT6307 Integrated Host Controller used for IEEE 1394A communication. When applied to an IEEE 1394 (also known as FireWire; i.LINK or Lynx) card, OHCI means that the card supports a standard interface to the PC and can be used by the OHCI IEEE 1394 drivers that come with all modern operating systems.
One Extensible Host Controller Interface (xHCI) controller and two Enhanced Host Controller Interface (EHCI) controllers are integrated into the X99 chipset, providing a total of up to 14 USB ports. Out of those ports, up to six can be configured as USB 3.0 ports with speeds of up to 5 Gbit/s per port, while the remaining are USB 2.0 ports with ...
The System Management Bus (SMBus or SMB) is a single-ended simple two-wire bus for the purpose of lightweight communication. Most commonly it is found in chipsets of computer motherboards for communication with the power source for ON/OFF instructions.
In 2003, and in conjunction with the i865 and i875 northbridges, the ICH5 was created. A SATA host controller was integrated. The ICH5R variant additionally supported RAID 0 on SATA ports. Eight USB-2.0 ports were available. The chip had full support for ACPI 2.0. It had 460 pins. Since 1999 the 266 MB/s hub interface was assumed to be a ...
Computer bus interfaces provided through the M.2 connector are PCI Express x4 (up to four lanes), Serial ATA 3.0, and USB 3.0 (a single logical port for each of the latter two). It is up to the manufacturer of the M.2 host or module to select which interfaces are to be supported, depending on the desired level of host support and the module type.
The written USB 3.0 specification was released by Intel and its partners in August 2008. The first USB 3.0 controller chips were sampled by NEC in May 2009, [4] and the first products using the USB 3.0 specification arrived in January 2010. [5] USB 3.0 connectors are generally backward compatible, but include new wiring and full-duplex operation.
USB 3.0 port provided by an ExpressCard-to-USB 3.0 adapter may be connected to a separately-powered USB 3.0 hub, with external devices connected to that USB 3.0 hub. On the motherboards of desktop PCs which have PCI Express (PCIe) slots (or the older PCI standard), USB 3.0 support can be added as a PCI Express expansion card.