Search results
Results from the WOW.Com Content Network
The structural channel, C-channel or parallel flange channel (PFC), is a type of (usually structural steel) beam, used primarily in building construction and civil engineering. Its cross section consists of a wide "web", usually but not always oriented vertically, and two "flanges" at the top and bottom of the web, only sticking out on one side ...
For example, a "W10x22" beam is approximately 10 in (254 mm) in depth with a nominal height of the I-beam from the outer face of one flange to the outer face of the other flange, and weighs 22 lb/ft (33 kg/m). Wide flange section beams often vary from their nominal depth. In the case of the W14 series, they may be as deep as 22.84 in (580 mm).
The best example is Flanges, there are multiple holes in the Flanges, the circle through the center of these holes is known as the pitch circle, and the diameter of this circle is known as Pitch Circle Diameter, in short PCD. PDM, PDMS: product data management, product data manager [app], product data management system [app]
The gap between the flange faces has been exaggerated by a factor of four to make it clearly visible. The choke flange can also be mated with a plain cover flange and still form a pressure seal. A choke connection is formed by mating one choke flange and one cover (or gasket/cover) flange. The central region of the choke flange face is very ...
The flange design, inner and outer conductor dimensions are standardized, by EIA, in the RS-225, 50 Ω (ohm), and RS-259, 75 Ω, standards.They are commonly referred to by the inner diameter of the outer conductor in fractional inches.
A truss can be thought of as a beam where the web consists of a series of separate members instead of a continuous plate. In the truss, the lower horizontal member (the bottom chord) and the upper horizontal member (the top chord) carry tension and compression, fulfilling the same function as the flanges of an I-beam.
The strong bond of the flange (horizontal section) and the two webs (vertical members, also known as stems) creates a structure that is capable of withstanding high loads while having a long span. The typical sizes of double tees are up to 15 feet (4.6 m) for flange width, up to 5 feet (1.5 m) for web depth, and up to 80 feet (24 m) or more for ...
Deflection (f) in engineering. In structural engineering, deflection is the degree to which a part of a long structural element (such as beam) is deformed laterally (in the direction transverse to its longitudinal axis) under a load.