Search results
Results from the WOW.Com Content Network
Two-stroke engines which use crankcase compression do not require a crankcase ventilation system, since all of the gases within the crankcase are then fed into the combustion chamber. Many small four-stroke engines such as lawn mower engines and electricity generators simply use a draught tube connected to the intake system.
The D-400 series engine or the Iron Horse engine was a light-duty two-stroke engine used for powering lawnmowers produced from the 1950s to the late 1970s. D-400 engines were single-cylinder engines designed and manufactured by the Outboard Marine Corporation (OMC; Johnson and Evinrude) for Lawn-Boy [2] and Masport. The D-400 engines displaced ...
Gardner 0 stationary engine (a plate acts as a safety shield but the crankshaft is not fully enclosed). Early engines were of the "open-crank" style, that is, there was no enclosed crankcase. The crankshaft and associated parts were open to the environment. That made for a messy environment, because oil spray from the moving parts was not ...
The Toyota F series engine was a series of OHV inline-6-cylinder engines produced by Toyota between November 1949 and 1992. They are known for their high amount of torque at low engine speeds, massive cast-iron blocks and heads and also their high reliability. The F engine had one of the longest production runs of any Toyota engine.
The increased engine power is not immediately available due to the need to sharply increase engine RPM, to build up pressure and to spin up the turbo, before the turbo starts to do any useful air compression. The increased intake volume causes increased exhaust and spins the turbo faster, and so forth until steady high power operation is reached.
An overhead valve engine, abbreviated (OHV) and sometimes called a pushrod engine, is a piston engine whose valves are located in the cylinder head above the combustion chamber. This contrasts with flathead (or "sidevalve") engines , where the valves were located below the combustion chamber in the engine block .
Hot water, being less dense, would rise to the top of the engine and up into the top of the radiator, descending to the bottom as it cooled, and back into the engine. (This was the direction of water flow in most cars which did have water pumps, until the introduction of crossflow radiator designs.) The thermosiphon system was susceptible to ...
Free-piston engine used as a gas generator to drive a turbine. A free-piston engine is a linear, 'crankless' internal combustion engine, in which the piston motion is not controlled by a crankshaft but determined by the interaction of forces from the combustion chamber gases, a rebound device (e.g., a piston in a closed cylinder) and a load device (e.g. a gas compressor or a linear alternator).