Search results
Results from the WOW.Com Content Network
A direct shear test is a laboratory or field test used by geotechnical engineers to measure the shear strength properties of soil [1] [2] or rock [2] material, or of discontinuities in soil or rock masses. [2] [3] The U.S. and U.K. standards defining how the test should be performed are ASTM D 3080, AASHTO T236 and BS 1377-7:1990
Direct shear test ASTM D3080. The direct shear test determines the consolidated, drained strength properties of a sample. A constant strain rate is applied to a single shear plane under a normal load, and the load response is measured. If this test is performed with different normal loads, the common shear strength parameters can be determined ...
2 Procedure for Testing Parts of IS 8543-19 3 Standard Test Methods for Tensile Properties of Plastics. ASTM : D 638-1991 4 Standard Test Methods for Thermoplastic Elastomers-Tension. ASTM : D 412-1992 (H) HYSD BARS; 1 Specifications for HYSD bars. IS 1786 – 1985 2 Specification for Mild Steel and Medium Tensile steel bars. IS 432 (P II) 1966
Tilt test on a fitting discontinuity. In geomechanics, a tilt test is a simple test to estimate the shear strength parameters of a discontinuity. [1] [2] Two pieces of rock containing a discontinuity are held in hand or mounted in test equipment with the discontinuity horizontal. The sample is slowly tilted until the top block moves.
A typical reference strain for the approximate occurrence of zero effective stress is 5% double amplitude shear strain. This is a soil test-based definition, usually performed via cyclic triaxial, cyclic direct simple shear, or cyclic torsional shear type apparatus. These tests are performed to determine a soil's resistance to liquefaction by ...
Triaxial apparatus with sample attached ready for testing. In materials science, a triaxial shear test is a common method to measure the mechanical properties of many deformable solids, especially soil (e.g., sand, clay) and rock, and other granular materials or powders.
Shear testing is the alternative method to determine the strength a bond can withstand. Various variants of shear testing exist. Like with pull testing, the objective is to recreate the failure mode of interest in the test. If that is not possible, the operator should focus on putting the highest possible load on the bond. [18]
The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil. This test is the most frequently used subsurface exploration drilling test performed worldwide. The test procedure is described in ISO 22476-3, ASTM D1586 [1] and Australian Standards AS ...