Search results
Results from the WOW.Com Content Network
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
8,388,608 bits (1,024 kibibytes), one of a few traditional meanings of megabyte: 10 7: 11,520,000 bits – capacity of a lower-resolution computer monitor (as of 2006), 800 × 600 pixels, 24 bpp: 11,796,480 bits – capacity of a 3.5 in floppy disk, colloquially known as 1.44 megabyte but actually 1.44 × 1000 × 1024 bytes 2 24: 16,777,216 ...
The kilobyte is a multiple of the unit byte for digital information. The International System of Units (SI) defines the prefix kilo as a multiplication factor of 1000 (10 3); therefore, one kilobyte is 1000 bytes. [1] The internationally recommended unit symbol for the kilobyte is kB. [1]
An alternative system of nomenclature for the same units (referred to here as the customary convention), in which 1 kilobyte (KB) is equal to 1,024 bytes, [38] [39] [40] 1 megabyte (MB) is equal to 1024 2 bytes and 1 gigabyte (GB) is equal to 1024 3 bytes is mentioned by a 1990s JEDEC standard. Only the first three multiples (up to GB) are ...
A group of 8 bits (8 bit) constitutes one byte (1 B). The byte is the most common unit of measurement of information (megabyte, mebibyte, gigabyte, gibibyte, etc.). The decimal SI prefixes kilo, mega etc., are powers of 10. The power of two equivalents are the binary prefixes kibi, mebi, etc. Accordingly: 1 kB = 1000 bytes = 8000 bits
For example, a kilobyte is actually 1024 bytes even though the standard meaning of kilo is 1000. And, mega normally means one million, but in computing is often used to mean 2 20 = 1 048 576. The table below illustrates the differences between normal metric sizes and the implied actual size – the binary size.
As 1024 (2 10) is approximately 1000 (10 3), roughly corresponding to SI multiples, it was used for binary multiples as well. In 1998 the International Electrotechnical Commission (IEC) published standards for binary prefixes , requiring that the gigabyte strictly denote 1000 3 bytes and gibibyte denote 1024 3 bytes.
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.