Search results
Results from the WOW.Com Content Network
Assorted SO-DIMM Modules A 200-pin PC2-5300 DDR2 SO-DIMM. A 204-pin PC3-10600 DDR3 SO-DIMM. A SO-DIMM slot on a computer motherboard. A SO-DIMM (pronounced "so-dimm" / ˈ s oʊ d ɪ m /, also spelled "SODIMM") or small outline DIMM, is a smaller alternative to a DIMM, being roughly half the physical size of a regular DIMM. The first SODIMMs had ...
DDR SDRAM for notebook computers, SO-DIMMs, have 200 pins, which is the same number of pins as DDR2 SO-DIMMs. These two specifications are notched very similarly and care must be taken during insertion if unsure of a correct match.
Since around the year 2000, most laptops have used SO-DIMM slots in which RAM is mounted, [47] although, as of 2021, an increasing number of models use memory soldered to the motherboard, either alongside SO-DIMM slots or without any slots and soldering all memory to the motherboard.
By consulting the documentation of your motherboard, or reading the labels on the board itself, you can determine the underlying logical structure of the slots. When there is more than one slot, they are numbered, and when there is more than one channel, the different slots are separated in that way as well – usually color-coded. [citation ...
DDR4 DIMM modules have a slightly curved edge connector so not all of the pins are engaged at the same time during module insertion, lowering the insertion force. [ 13 ] DDR4 SO-DIMMs have 260 pins instead of the 204 pins of DDR3 SO-DIMMs, spaced at 0.5 rather than 0.6 mm, and are 2.0 mm wider (69.6 versus 67.6 mm), but remain the same 30 mm in ...
PC2-5300 DDR2 SO-DIMM (for notebooks) Comparison of memory modules for desktop PCs (DIMM) Comparison of memory modules for portable/mobile PCs (SO-DIMM) The key difference between DDR2 and DDR SDRAM is the increase in prefetch length. In DDR SDRAM, the prefetch length was two bits for every bit in a word; whereas it is four bits in DDR2 SDRAM.
PC133 refers to SDR SDRAM operating at a clock frequency of 133 MHz, on a 64-bit-wide bus, at a voltage of 3.3 V. PC133 is available in 168-pin DIMM and 144-pin SO-DIMM form factors. PC133 is the fastest and final SDR SDRAM standard ever approved by the JEDEC, and delivers a bandwidth of 1.066 GB per second ([133.33 MHz * 64/8]=1.066 GB/s).
Compression Attached Memory Module (CAMM) is a memory module form factor which uses a land grid array, and developed at Dell by engineer Tom Schnell as a replacement for DIMMs and SO-DIMMs which use edge connectors and had been in use for about 25 years. [1] The first SO-DIMMs were introduced by JEDEC in 1997. [2] [3] [4] [5]