Search results
Results from the WOW.Com Content Network
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
While 1 atm (194 dB peak or 191 dB SPL) [11] [12] is the largest pressure variation an undistorted sound wave can have in Earth's atmosphere (i. e., if the thermodynamic properties of the air are disregarded; in reality, the sound waves become progressively non-linear starting over 150 dB), larger sound waves can be present in other atmospheres ...
Sound exposure level (SEL) is a logarithmic measure of the sound exposure of a sound relative to a reference value. Sound exposure level, denoted L E and measured in dB , is defined by [ 1 ]
In engineering, attenuation is usually measured in units of decibels per unit length of medium (dB/cm, dB/km, etc.) and is represented by the attenuation coefficient of the medium in question. [1] Attenuation also occurs in earthquakes; when the seismic waves move farther away from the hypocenter, they grow smaller as they are attenuated by the ...
Noise is a term often used to refer to an unwanted sound. In science and engineering, noise is an undesirable component that obscures a wanted signal. However, in sound perception it can often be used to identify the source of a sound and is an important component of timbre perception (see below).
The sound energy density level gives the ratio of a sound incidence as a sound energy value in comparison to the reference level of 1 pPa (= 10 −12 pascals). [2] It is a logarithmic measure of the ratio of two sound energy densities. The unit of the sound energy density level is the decibel (dB), a non-SI unit accepted for use with the SI ...
Scaletti agreed that sound has the power to convey a lot of meaning. "People know that because of language," she said, "but they think everything else is music." That's why she's carving a new ...
Reverberation time is a measure of the time required for the sound to "fade away" in an enclosed area after the source of the sound has stopped. When it comes to accurately measuring reverberation time with a meter, the term T 60 [6] (an abbreviation for reverberation time 60 dB) is used.