Search results
Results from the WOW.Com Content Network
A binary trigger is a trigger for a semiautomatic firearm that drops the hammer both when the trigger is pulled, and also when it is released. Examples include the AR-15 series of rifles, produced by Franklin Armory, Fostech Outdoors, and Liberty Gun Works. The AR-15 trigger as produced by Liberty Gun Works only functions in pull and release ...
A disassembled Mauser action showing a partially disassembled receiver and bolt. In firearms terminology and law, the firearm frame or receiver is the part of a firearm which integrates other components by providing housing for internal action components such as the hammer, bolt or breechblock, firing pin and extractor, and has threaded interfaces for externally attaching ("receiving ...
Sear shown in a revolver action. In a firearm, the sear is the part of the trigger mechanism that holds the hammer, striker, or bolt back until the correct amount of pressure has been applied to the trigger, at which point the hammer, striker, or bolt is released to discharge the weapon.
Rifles styled like the AR-15 come in many sizes and have many options, depending on the manufacturer. The lower receiver, without the receiver extension, rear takedown pin, and buttstock, is shown at bottom. An AR-15–style rifle is a lightweight semi-automatic rifle based on or similar to the Colt AR-15 design.
The hammer itself cannot contact a loaded cartridge, but must instead strike the transfer bar, which then contacts the cartridge primer with the spur or pin. The transfer bar is normally positioned out of line with the hammer's travel, but is moved into place by the normal action of the trigger, providing similar "drop safety" to a firing pin ...
Length of pull: The distance between the trigger and the butt end of the shoulder stock of a rifle or shotgun. Lever-action rifle. Lever-action: A type of firearm action with a lever that encircles the trigger guard area, (often including the trigger guard itself) to load fresh cartridges into the chamber of the barrel when the lever is worked.
Charging handle being pulled on an M2 machine gun. The cocking handle, also known as charging handle or bolt handle, is a device on a firearm which, when manipulated, results in the bolt being pulled to the rear, putting the hammer/striker into a spring-loaded ("cocked") "ready and set" position, allowing the operator to open the breech and eject any spent/unwanted cartridge/shell from the ...
The hammer itself is a metal piece that forcefully rotates about a pivot point. [2] The term tumbler can refer to a part of the hammer or a part mechanically attached to the pivot-point of the hammer, depending on the particular firearm under discussion (see half-cock). According to one source the term tumbler is synonymous with hammer. [3] [4]