Ads
related to: rule bilge pump 1100 automatic boat anchor bar and water
Search results
Results from the WOW.Com Content Network
The bilge pump was an improvement on the first hydraulic pumps used in antiquity: force pumps. Invented around the early 3rd century BCE, the most primitive design of a force pump consisted of a piston pushing water out of a tube, constructed by soldering individual bronze elements (Stein 246).
A bilge pump is a water pump used to remove bilge water. Since fuel can be present in the bilge, electric bilge pumps are designed to not cause sparks. Electric bilge pumps are often fitted with float switches which turn on the pump when the bilge fills to a set level. Since bilge pumps can fail, use of a backup pump is often advised. The ...
They are found on board ships where they are used to separate oil from oily waste water such as bilge water before the waste water is discharged into the environment. These discharges of waste water must comply with the requirements laid out in Marpol 73/78. [1] Bilge water is a nearly-unavoidable byproduct of shipboard operations.
Bilge compartment in a steel hulled ship (looking down) Bilge compartment and pump. The bilge / b ɪ l dʒ / of a ship or boat is the part of the hull that would rest on the ground if the vessel were unsupported by water. The "turn of the bilge" is the transition from the bottom of a hull to the sides of a hull.
The machinery is specifically designed for anchor handling operations. They also have arrangements for quick anchor release, which is operable from the bridge or other normally crewed locations in direct communication with the bridge. The reference load used in the design and testing of the towing winch is twice the static bollard pull.
The line allows the anchor to be unhooked from an obstruction, such as a rock or another vessel's anchor cable, so preventing raising the anchor in the normal way. [13] anchor chain . Also anchor cable. A chain connecting a ship to an anchor. anchor detail A group of men who handle ground tackle when the ship is anchoring or getting under way ...
A pump-jet works by having an intake (usually at the bottom of the hull) that allows water to pass underneath the vessel into the engines. Water enters the pump through this inlet. The pump can be of a centrifugal design for high speeds, or an axial flow pump for low to medium speeds. The water pressure inside the inlet is increased by the pump ...
A bilge keel. A bilge keel is a nautical device used to reduce a ship's tendency to roll. Bilge keels are employed in pairs (one for each side of the ship). [1] A ship may have more than one bilge keel per side, but this is rare. Bilge keels increase hydrodynamic resistance, making the ship roll less. [2] Bilge keels are passive stability systems.
Ads
related to: rule bilge pump 1100 automatic boat anchor bar and water