Search results
Results from the WOW.Com Content Network
Torque charts are available to specify the required torque for a given fastener based on its property class (fineness of manufacture and fit) and grade (tensile strength). Spring Analogy for a Bolted Joint. When a fastener is tightened, a tension preload is develops in the bolt, while an equal compressive preload forms in the clamped parts.
In meteorology, prevailing wind in a region of the Earth's surface is a surface wind that blows predominantly from a particular direction. The dominant winds are the trends in direction of wind with the highest speed over a particular point on the Earth's surface at any given time.
The wind imparts a torque on the wind turbine, thrust is a necessary by-product of torque. Newtonian physics dictates that for every action there is an equal and opposite reaction. If the wind imparts torque on the blades, then the blades must be imparting torque on the wind. This torque would then cause the flow to rotate.
Torque is caused by a change in the apparent wind direction relative to the moving blades. Another advantage of the helical twist is that the blades generate torque well from upward-slanting airflow. [ citation needed ] This is negligible in open country, but tall buildings and cliff faces generate a bow wave which directs airflow up and over them.
Consequently, a wind blowing from the north has a wind direction referred to as 0° (360°); a wind blowing from the east has a wind direction referred to as 90°, etc. Weather forecasts typically give the direction of the wind along with its speed, for example a "northerly wind at 15 km/h" is a wind blowing from the north at a speed of 15 km/h ...
Whereas the streamtube area is reduced by a propeller, it is expanded by a wind turbine. For either application, a highly simplified but useful approximation is the Rankine–Froude "momentum" or "actuator disk" model (1865, [1] 1889 [2]). This article explains the application of the "Betz limit" to the efficiency of a ground-based wind turbine.
A vehicle behaves as though it is directly experiencing a lateral effect of the magnitude of the crosswind component only. The crosswind component is computed by multiplying the wind speed by the sine of the angle between the wind and the direction of travel while the headwind component is computed in the same manner, using cosine instead of sine.
Crosswind kite power is power derived from airborne wind-energy conversion systems (AWECS, also AWES) or crosswind kite power systems (CWKPS). The kite system is characterized by energy-harvesting parts flying transversely to the direction of the ambient wind, i.e., to crosswind mode; sometimes the entire wing set and tether set are flown in crosswind mode.