Search results
Results from the WOW.Com Content Network
Angle bead, a projecting wood moulding at the corner of a plastered wall [4] Corner bead is similar, [4] but is usually fully embedded in plaster or drywall, and usually plastic or metal; Nosing bead, the rounded projection of a stair tread over the riser below [4] Parting bead, or parting strip, the feature that separates two sashes in a sash ...
Angle brackets feature holes in them for screws. A typical example use of is a shelf bracket for mounting a shelf on a wall. In general, angle brackets have a wide range of applications, and are used, among other things, in building construction , mechanical engineering or to join two pieces of furniture
First fix comprises all the work needed to take a building from foundation to putting plaster on the internal walls. This includes constructing walls, floors and ceilings, and inserting cables for electrical supply and pipes for water supply. Some argue that First Fix starts after the shell of the building is complete, and ends when the walls ...
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
Veneer is obtained either by "peeling" the trunk of a tree or by slicing large rectangular blocks of wood known as flitches. The appearance of the grain and figure in wood comes from slicing through the growth rings of a tree and depends upon the angle at which the wood is sliced. There are three main types of veneer-making equipment used ...
The staff bead, a 1-inch dowel with approx 1 ⁄ 3 shaved off the back, is set on the external corner by the joiner on site, fastened to wooden plugs set into the brick/block seams, or to the wood frame. Plaster is run up to the staff bead and then cut back locally to the bead or "quirked" to avoid a weak feather edge where the plaster meets ...
Wattle and daub is a composite building method used for making walls and buildings, in which a woven lattice of wooden strips called "wattle" is "daubed" with a sticky material usually made of some combination of wet soil, clay, sand, animal dung and straw. Wattle and daub has been used for at least 6,000 years and is still an important ...