Search results
Results from the WOW.Com Content Network
Internal erosion is the formation of voids within a soil caused by the removal of material by seepage. [1] It is the second most common cause of failure in levees and one of the leading causes of failures in earth dams, [2] responsible for about half of embankment dam failures. [3]
If the soil particles in a sample are predominantly in a relatively narrow range of sizes, the sample is uniformly graded. If a soil sample has distinct gaps in the gradation curve, e.g., a mixture of gravel and fine sand, with no coarse sand, the sample may be gap graded. Uniformly graded and gap graded soils are both considered to be poorly ...
Seep is often used in environmental sciences to define an exfiltration zone (seepage zone) where contaminated water, e.g., from waste dumps, leaves a waste system area. Seeps are often important smaller wildlife water sources, and indicated by lower riparian vegetation.
A soil test is a laboratory or in-situ analysis to determine the chemical, physical or biological characteristics of a soil. Possibly the most widely conducted soil tests are those performed to estimate the plant-available concentrations of nutrients in order to provide fertilizer recommendations in agriculture.
Soil physics is the study of soil's physical properties and processes. It is applied to management and prediction under natural and managed ecosystems. Soil physics deals with the dynamics of physical soil components and their phases as solids, liquids, and gases. It draws on the principles of physics, physical chemistry, engineering, and ...
The available volume for additional water in the soil depends on the porosity of the soil [7] and the rate at which previously infiltrated water can move away from the surface through the soil. The maximum rate at that water can enter soil in a given condition is the infiltration capacity.
This phenomenon of soil behaviour can be included in the Hardening Soil model by means of a dilatancy cut-off. In order to specify this behaviour, the initial void ratio, e i n i t {\displaystyle e_{init}} , and the maximum void ratio, e m a x {\displaystyle e_{max}} , of the material must be entered as general parameters.
The cone penetration or cone penetrometer test (CPT) is a method used to determine the geotechnical engineering properties of soils and delineating soil stratigraphy. It was initially developed in the 1950s at the Dutch Laboratory for Soil Mechanics in Delft to investigate soft soils. Based on this history it has also been called the "Dutch ...