Search results
Results from the WOW.Com Content Network
Pulse width also constrains the range discrimination, that is the capacity of the radar to distinguish between two targets that are close together. At any range, with similar azimuth and elevation angles and as viewed by a radar with an unmodulated pulse, the range resolution is approximately equal in distance to half of the pulse duration ...
Pulse compression is a signal processing technique commonly used by radar, sonar and echography to either increase the range resolution when pulse length is constrained or increase the signal to noise ratio when the peak power and the bandwidth (or equivalently range resolution) of the transmitted signal are constrained.
The range resolution is the minimal range separation between two objects traveling at the same speed before the radar can detect two discrete reflections: = (). In addition to this sampling limit, the duration of the transmitted pulse could mean that returns from two targets will be received simultaneously from different parts of the pulse.
Range ambiguity resolution is a technique used with medium pulse-repetition frequency (PRF) radar to obtain range information for distances that exceed the distance between transmit pulses. This signal processing technique is required with pulse-Doppler radar. [1] [2] [3]
Range and velocity can both be identified using medium PRF, but neither one can be identified directly. Medium PRF is from 3 kHz to 30 kHz, which corresponds with radar range from 5 km to 50 km. This is the ambiguous range, which is much smaller than the maximum range. Range ambiguity resolution is used to determine true range in medium PRF radar.
Pulse Doppler radar may have 50 or more pulses between the radar and the reflector. Pulse Doppler relies on medium pulse repetition frequency (PRF) from about 3 kHz to 30 kHz. Each transmit pulse is separated by 5 km to 50 km distance. Range and speed of the target are folded by a modulo operation produced by the sampling process.
The range and velocity of a target are detected through pulse delay ranging and the Doppler effect (pulse-Doppler), or through the frequency modulation (FM) ranging and range differentiation. The range resolution is limited by the instantaneous signal bandwidth of the radar sensor in both pulse-Doppler and frequency modulated continuous wave ...
Radars measure range based on the time between transmission and reception, and the resolution of that measurement is a function of the length of the received pulse. This leads to the basic outcome that increasing the pulse width allows the radar to detect objects at longer range but at the cost of decreasing the accuracy of that range measurement.