enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Standard RAID levels - Wikipedia

   en.wikipedia.org/wiki/Standard_RAID_levels

   Diagram of a RAID 1 setup. RAID 1 consists of an exact copy (or mirror) of a set of data on two or more disks; a classic RAID 1 mirrored pair contains two disks.This configuration offers no parity, striping, or spanning of disk space across multiple disks, since the data is mirrored on all disks belonging to the array, and the array can only be as big as the smallest member disk.

3. Nested RAID levels - Wikipedia

   en.wikipedia.org/wiki/Nested_RAID_levels

   As a RAID 0 array striped across RAID 5 elements, minimal RAID 50 configuration requires six drives. On the right is an example where three collections of 120 GB RAID 5s are striped together to make 720 GB of total storage space. One drive from each of the RAID 5 sets could fail without loss of data; for example, a RAID 50 configuration ...

4. RAID - Wikipedia

   en.wikipedia.org/wiki/RAID

   RAID (/ r eɪ d /; redundant array of inexpensive disks or redundant array of independent disks) [1] [2] is a data storage virtualization technology that combines multiple physical data storage components into one or more logical units for the purposes of data redundancy, performance improvement, or both.

5. Data striping - Wikipedia

   en.wikipedia.org/wiki/Data_striping

   In some RAID configurations, such as RAID 0, failure of a single member drive of the RAID array causes all stored data to be lost. In other RAID configurations, such as a RAID 5 that contains distributed parity and provides redundancy , if one member drive fails the data can be restored using the other drives in the array.

6. Disk array controller - Wikipedia

   en.wikipedia.org/wiki/Disk_array_controller

   Those RAID systems made their way to the consumer market, for users wanting the fault-tolerance of RAID without investing in expensive SCSI drives. Fast consumer drives make it possible to build RAID systems at lower cost than with SCSI, but most ATA RAID controllers lack a dedicated buffer or high-performance XOR hardware for parity calculation.

7. Mass storage - Wikipedia

   en.wikipedia.org/wiki/Mass_storage

   Devices and/or systems that have been described as mass storage include tape libraries, RAID systems, and a variety of computer drives such as hard disk drives (HDDs), magnetic tape drives, magneto-optical disc drives, optical disc drives, memory cards, and solid-state drives (SSDs). It also includes experimental forms like holographic memory.

8. Trim (computing) - Wikipedia

   en.wikipedia.org/wiki/Trim_(computing)

   However, Red Hat recommends against using software RAID levels 1, 4, 5, and 6 on SSDs with most RAID technologies, because during initialization, most RAID management utilities (e.g. Linux's mdadm) write to all blocks on the devices to ensure that checksums (or drive-to-drive verifies, in the case of RAID 1 and 10) operate properly, causing the ...

9. Non-standard RAID levels - Wikipedia

   en.wikipedia.org/wiki/Non-standard_RAID_levels

   The four-drive example is identical to a standard RAID 1+0 array, while the three-drive example is a software implementation of RAID 1E. The two-drive example is equivalent to RAID 1. [13] The driver also supports a "far" layout, in which all the drives are divided into f sections. All the chunks are repeated in each section but are switched in ...