Search results
Results from the WOW.Com Content Network
A chassis ground is a link between different metallic parts of a machine to ensure an electrical connection between them. [1] Examples include electronic instruments and motor vehicles. Usages
In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met. Isolation testing may also be conducted between one or more electrical circuits of the same ...
In some very commonly used miniature D connectors, it is possible that a bent pin can touch two neighboring contacts plus a grounded connector shell, thus shorting chassis ground to three electrical paths. The connector in Figure 3 is an example: its mating plug connector (not shown) fits inside the Figure 3 receptacle shell, and the plug's ...
Floating grounds can be dangerous if they are caused by failure to properly ground equipment that was designed to require grounding because the chassis can be at a very different potential from that of any nearby organisms, who then get an electric shock upon touching it. Live chassis TVs, also known as hot chassis, where the set's ground is ...
Battery 15 battery+ through ignition switch 16, 54/15 30 from battery+ direct 30/51 30a from 2nd battery and 12/24 V relay: 31 return to battery- or direct to ground 31a return to battery- 12/24 V relay 31b return to battery- or ground through switch 85d 31c return to battery- 12/24 V relay 31, 31a Electric motors; 32 return 31 33
$07 Minimum voltage for test; $08 Maximum voltage for test; $09 Time between voltage transitions in ms; See OBD-II PIDs#Service_05 for a list. Service / Mode $06 is a Request for On-Board Monitoring Test Results for Continuously and Non-Continuously Monitored System. There are typically a minimum value, a maximum value, and a current value for ...
The use of the term ground (or earth) is so common in electrical and electronics applications that circuits in portable electronic devices, such as cell phones and media players, as well as circuits in vehicles, may be spoken of as having a "ground" or chassis ground connection without any actual connection to the Earth, despite "common" being ...
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...