Search results
Results from the WOW.Com Content Network
A wildcard mask is a mask of bits that indicates which parts of an IP address are available for examination. In the Cisco IOS, [1] they are used in several places, for example: To indicate the size of a network or subnet for some routing protocols, such as OSPF. To indicate what IP addresses should be permitted or denied in access control lists ...
Since the introduction of CIDR, however, the assignment of an IP address to a network interface requires two parameters, the address and a subnet mask. Given an IPv4 source address, its associated subnet mask, and the destination address, a router can determine whether the destination is on a locally connected network or a remote network. The ...
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
Common uses for ifconfig include setting the IP address and subnet mask of a network interface and disabling or enabling an interface. [1] At boot time, many Unix-like operating systems initialize their network interfaces with shell scripts that call ifconfig. As an interactive tool, system administrators routinely use the utility to display ...
Hop-by-hop is the fundamental characteristic of the IP Internet layer [1] and the OSI Network Layer. When a router interface is configured with an IP address and subnet mask, the interface becomes a host on that attached network. A directly connected network is a network that is directly attached to one of the router interfaces.
The default route in Internet Protocol Version 4 (IPv4) is designated as the zero address, 0.0.0.0 / 0 in CIDR notation. [2] Similarly, in IPv6, the default route is specified by :: / 0. The subnet mask is specified as / 0, which effectively specifies all networks and is the shortest match possible. A route lookup that does not match any other ...
This is a list of all Internet Relay Chat commands from RFC 1459, RFC 2812, and extensions added to major IRC daemons. Most IRC clients require commands to be preceded by a slash (" / "). Some commands are actually sent to IRC bots ; these are treated by the IRC protocol as ordinary messages, not as / -commands.
A 0-bit indicates that the address bit must be considered (exact match); a 1-bit in the mask is a "don't care". This table further explains the concept. Mask example: network address (traffic that is to be processed): 192.0.2.0. mask: 0.0.0.255. network address (binary): 11000000.00000000.00000010.00000000 mask (binary): 00000000.00000000 ...