Ads
related to: half wave rectifier op amp
Search results
Results from the WOW.Com Content Network
The precision rectifier, sometimes called a super diode, is an operational amplifier (opamp) circuit configuration that behaves like an ideal diode and rectifier. [ 1 ] The op-amp-based precision rectifier should not be confused with the power MOSFET-based active rectification ideal diode.
Between the circuit's input and output is a diode that performs half-wave rectification, allowing substantial current flow only when the input voltage is around a diode drop higher than the output terminal. The output is connected to a capacitor of value and resistor of value in parallel to ground. The capacitor is charged as the input voltage ...
In half-wave rectification of a single-phase supply, either the positive or negative half of the AC wave is passed, while the other half is blocked. Because only one half of the input waveform reaches the output, mean voltage is lower. Half-wave rectification requires a single diode in a single-phase supply, or three in a three-phase supply.
An operational amplifier (often op amp or opamp) is a DC-coupled electronic voltage amplifier with a differential input, a (usually) single-ended output, [1] and an extremely high gain. Its name comes from its original use of performing mathematical operations in analog computers .
where Z dif is the op-amp's input impedance to differential signals, and A OL is the open-loop voltage gain of the op-amp (which varies with frequency), and B is the feedback factor (the fraction of the output signal that returns to the input). [3] [4] In the case of the ideal op-amp, with A OL infinite and Z dif infinite, the input impedance ...
The 866 is a mercury vapor half-wave rectifier intended for high-voltage applications. The voltage drop is approximately 15 volts up to 150 Hz. To avoid unwanted shorts the tube must be operated in a vertical position and the filament preheated for at least 30 seconds before applying the plate voltage.
The characteristics and components of ripple depend on its source: there is single-phase half- and full-wave rectification, and three-phase half- and full-wave rectification. Rectification can be controlled (uses Silicon Controlled Rectifiers (SCRs)) or uncontrolled (uses diodes). There is in addition, active rectification which uses transistors.
In areas using 110–120 volt AC, a simple half-wave rectifier limited the maximum plate voltage that could be developed; this was adequate for relatively low-power audio equipment, but television receivers or higher-powered amplifiers required either a more complex voltage doubler rectifier or warranted the use of a power transformer with a ...
Ads
related to: half wave rectifier op amp