Search results
Results from the WOW.Com Content Network
A system bus is a single computer bus that connects the major components of a computer system, combining the functions of a data bus to carry information, an address bus to determine where it should be sent or read from, and a control bus to determine its operation. The technique was developed to reduce costs and improve modularity, and ...
An address bus is a bus that is used to specify a physical address. When a processor or DMA-enabled device needs to read or write to a memory location, it specifies that memory location on the address bus (the value to be read or written is sent on the data bus). The width of the address bus determines the amount of memory a system can address.
In computer architecture, a control bus is part of the system bus and is used by CPUs for communicating with other devices within the computer. While the address bus carries the information about the device with which the CPU is communicating and the data bus carries the actual data being processed, the control bus carries commands from the CPU and returns status signals from the devices.
The Unibus was the earliest of several computer bus and backplane designs used with PDP-11 and early VAX systems manufactured by the Digital Equipment Corporation (DEC) of Maynard, Massachusetts. The Unibus was developed around 1969 by Gordon Bell and student Harold McFarland while at Carnegie Mellon University .
The A20, or address line 20, is one of the electrical lines that make up the system bus of an x86-based computer system. The A20 line in particular is used to transmit the 21st bit on the address bus. A microprocessor typically has a number of address lines equal to the base-two logarithm of the number of words in its physical address space.
large bus-widths (64/128/256/512/1024 bit). A simple transaction on the AHB consists of an address phase and a subsequent data phase (without wait states: only two bus-cycles). Access to the target device is controlled through a MUX (non-tristate), thereby admitting bus-access to one bus-master at a time.
For example, in a computer, address information is transmitted synchronously—the address bits over the address bus, and the read or write strobes of the control bus. Single-wire synchronous signalling. A logical one is indicated when there are two transitions in the same time frame as a zero.
An address decoder is also used to select the appropriate one of multiple memory modules or memory chips when a particular address is provided by the processor system's address bus. For this purpose, the memory modules or memory chips have selection inputs, usually referred to as chip select pin (CS) or chip enable pin (CE) pin.