enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Araldite - Wikipedia

   en.wikipedia.org/wiki/Araldite

   The first batches of Araldite epoxy resins, for which the brand is best known, were made in Duxford, England in 1950. [1] Araldite adhesive sets by the interaction of an epoxy resin with a hardener. Mixing an epoxy resin and hardener together starts a chemical reaction that produces heat – an exothermic reaction. [2]

3. J-B Weld - Wikipedia

   en.wikipedia.org/wiki/J-B_Weld

   The mixture sets in 4-6 hours and fully cures in up to 15 hours. It can be used as an adhesive, laminate, plug, filler, sealant, or electrical insulator and can be drilled, ground, tapped, machined, sanded, and painted when cured. J-B Kwik is a faster-curing two-part epoxy with medium-temperature resistance up to 300 °F (149 °C).

4. Wood glue - Wikipedia

   en.wikipedia.org/wiki/Wood_glue

   Liquid versions of hide glue are now available; typically they have urea added to keep the glue liquid at room temperature and to extend drying time. Examples of liquid hide glue are Old Brown Glue or Titebond Liquid Hide. Hide glue does not creep. Hide glue joints are easy to repair, by just heating and adding more hide glue. [7] [8] [9]

5. Adhesive bonding - Wikipedia

   en.wikipedia.org/wiki/Adhesive_bonding

   Depending on the chemical basis, some adhesive types have limited thermal and chemical resistance and the mechanical properties of the bond are temperature dependent. Therefore, choose a type of adhesive that has been developed to have good thermal and chemical resistance, such as reactive hot melt adhesives.

6. Hot-melt adhesive - Wikipedia

   en.wikipedia.org/wiki/Hot-melt_adhesive

   The bonding temperature is lower than with most other HMAs, only about 50 °C (122 °F) to 70 °C (158 °F), when the adhesive behaves as a soft rubber acting as a pressure-sensitive adhesive. The surface wetting in this amorphous state is good, and on cooling the polymer crystallizes, forming a strong flexible bond with high cohesion.

7. Redux (adhesive) - Wikipedia

   en.wikipedia.org/wiki/Redux_(adhesive)

   The coated joints are then allowed to stand for between 30 minutes and 72 hours, then the components are brought together under elevated pressure and temperature. The curing process is by condensation and a typical figure for Redux Liquid 775/Powder 775 is 30 minutes at 293 °F (145 °C) under a pressure of 100 psi (690 kPa).