Search results
Results from the WOW.Com Content Network
Northbridge or host bridge for PowerPC CPU is an Integrated Circuit (IC) for interfacing PowerPC CPU with memory, and Southbridge IC. Some Northbridge also provide interface for Accelerated Graphics Ports (AGP) bus, Peripheral Component Interconnect (PCI), PCI-X, PCI Express, or Hypertransport bus.
These microprocessors implement the "Amazon", or "PowerPC-AS", instruction set architecture (ISA). Amazon is a superset of the PowerPC instruction set, with the addition of special features not in the PowerPC specification, mainly derived from POWER2 [citation needed] and the original AS/400 processor, and has been 64-bit from the start.
While the machine state register found in the PowerPC architecture and the model-specific registers found in IA-32 and x86-64 architectures fulfill similar functions and the initialism "MSR" can refer to either, there are important differences that distinguish them. The machine state register, a single register, provides coarse-grained control ...
A typical north/southbridge layout (2015) A typical north/southbridge layout (2007) In computing, a northbridge (also host bridge, or memory controller hub) is a microchip that comprises the core logic chipset architecture on motherboards to handle high-performance tasks, especially for older personal computers.
The PowerPC e5500 is a 64-bit Power ISA-based microprocessor core from Freescale Semiconductor. The core implements most [ 1 ] of the core of the Power ISA v.2.06 with hypervisor support, but not AltiVec .
One key benefit of the new 64-bit prefixed instructions is the extension of immediates in branches to 34-bit. The spec was revised in September 2021 to the Power ISA v.3.1B spec. [ 19 ] [ 30 ] The spec was revised in May 2024 to the Power ISA v.3.1C spec. [ 19 ] [ 31 ]
The existing POWER and the upcoming PowerPC ISAs were deemed unsuitable by the AS/400 team so an extension to the 64-bit PowerPC instruction set was developed called PowerPC AS for Advances Series or Amazon Series. Later, additions from the RS/6000 team and AIM Alliance PowerPC were included, and by 2001, with the introduction of POWER4, they ...
DMI 1.0, introduced in 2004 with a data transfer rate of 1 GB/s with a ×4 link.. DMI 2.0, introduced in 2011, doubles the data transfer rate to 2 GB/s with a ×4 link.It is used to link an Intel CPU with the Intel Platform Controller Hub (PCH), which supersedes the historic implementation of a separate northbridge and southbridge.