enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drift pin - Wikipedia

   en.wikipedia.org/wiki/Drift_pin

   In metalworking, a drift pin, drift pin punch, simply drift, is the name for a tool used for localizing a hammer blow. A drift is smaller in diameter than the hammer face, thus concentrating the force into a smaller area. A drift is also used where the surrounding surfaces need to be protected from the hammer blow.

3. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...

4. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw. There are three different drive systems: manual, ratchet, and hydraulic. [2]

5. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   Other holes, reamed slightly larger in other parts, will fit these pins accurately, but not so tightly as to make disassembly difficult. This type of alignment is common in the joining of split crankcase halves such as are used in motorcycle motors and boxer type engines. After joining the halves, the assembled case may then be line bored ...

6. Digging bar - Wikipedia

   en.wikipedia.org/wiki/Digging_bar

   A lining bar is used to shift the alignment of railroad tracks, to manipulate some types of railroad track jacks, to "nip up" or lift ties and rails, and as a digging tool. Lining bars have a tapered form. They often have a square cross section between one and 1-1/2 inches at one end. They may have a pyramidal, wedge, or pinch point.

7. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   This is a single-hole punch which also crimps a metal fastening loop around the hole, similar to a rivet. It is used to permanently secure a few sheets of paper together. A similar tool, generally known as a holing pincer, is used in animal husbandry. A common application is to attach an ear tag to a livestock animal.