Search results
Results from the WOW.Com Content Network
Liquefaction is used for analyzing the fundamental properties of gas molecules (intermolecular forces), or for the storage of gases, for example: LPG, and in refrigeration and air conditioning. There the gas is liquefied in the condenser , where the heat of vaporization is released, and evaporated in the evaporator , where the heat of ...
Superabsorbent polymer: Polymer that can absorb and retain extremely large amounts of a liquid relative to its own mass. [5] Notes: The liquid absorbed can be water or an organic liquid. The swelling ratio of a superabsorbent polymer can reach the order of 1000:1. Superabsorbent polymers for water are frequently polyelectrolytes.
As an example of the latter, a "major commercial application of liquefaction is the liquefaction of air to allow separation of the constituents, such as oxygen, nitrogen, and the noble gases." [4] Another is the conversion of solid coal into a liquid form usable as a substitute for liquid fuels. [5]
This super-absorbent polymer (SAP) has the ability to absorb 100 to 1000 times its mass in water. Sodium polyacrylate is an anionic polyelectrolyte [2] with negatively charged carboxylic groups in the main chain. It is a polymer made up of chains of acrylate compounds. It contains sodium, which gives it the ability to absorb large amounts of water.
A small amount of superabsorbent polymer material is taken (0.1g) and it is placed in the beaker. 100 ml of deionized water is poured into the beaker. After 20 min the swollen polymer was separated by using [filter paper] By weighing the polymer, one can find the swollen capacity of the SAP material. [3]
In polymer chemistry, suspension polymerization is a heterogeneous radical polymerization process that uses mechanical agitation to mix a monomer or mixture of monomers in a liquid phase, such as water, while the monomers polymerize, forming spheres of polymer. [2] The monomer droplets (size of the order 10-1000 μm) are suspended in the liquid ...
The liquid molecules are more attracted to other liquid molecules as compared to the polymer surface. Because the polymer surfaces are solid surfaces, surface tension cannot be measured in a traditional way such as using a Wilhelmy plate. Instead, contact angles can be used to indirectly estimate the surface tension of polymer surfaces. [3]
The opposite process—spreading of a liquid on a substrate—is called wetting. The factor determining the spontaneous spreading and dewetting for a drop of liquid placed on a solid substrate with ambient gas, is the so-called spreading coefficient S: Surface tension diagram of a liquid droplet on a solid substrate.