enow.com Web Search

  1. Ads

    related to: 3 inch flexible air duct hose

Search results

  1. Results from the WOW.Com Content Network
  2. Marman clamp - Wikipedia

    en.wikipedia.org/wiki/Marman_clamp

    Aerospace pipe fittings with flanges for Marman clamps: a semi-rigid bleed air duct from a jet engine (left) and a semi-flexible fuel hose (right). A common use for Marman clamps is as quick-disconnect connectors in flexible aircraft fuel lines. [2]

  3. Umbilical cable - Wikipedia

    en.wikipedia.org/wiki/Umbilical_cable

    [2] [3] For shallow water surface supply air diving, the diver's umbilical is typically a 3-part umbilical comprising a 3 ⁄ 8 inch (9.5 mm) bore breathing gas hose, 1 ⁄ 4 inch (6.4 mm) bore pneumofathometer ("pneumo") hose, and diver communications cable, which usually also serves as a lifeline strength member. The pneumo hose is open at ...

  4. Air line - Wikipedia

    en.wikipedia.org/wiki/Air_line

    Two types of air line hose. Air line hoses are flexible tubes used to convey pressurised air. They are commonly used for carrying a supply of compressed air to operate pneumatic powered systems, such as a road vehicle air brake system for large vehicles and a railway air brake system for railway carriages / locomotives. [2]

  5. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    An advantage of flexible rubber fittings is that they can accommodate small misalignments and can be flexed slightly for installation in tight locations. [ 22 ] : 147, 149 A flexible fitting may be preferred to connect a shower or heavy tub to the drainage system without transmitting slight movements or stresses, which could eventually cause ...

  6. Duct (industrial exhaust) - Wikipedia

    en.wikipedia.org/wiki/Duct_(industrial_exhaust)

    Industrial exhaust ducts are pipe systems that connect hoods to industrial chimneys through other components of exhaust systems like fans, collectors, etc. Ducts are low-pressure pneumatic conveyors to convey dust, particles, shavings, fumes, or chemical hazardous components from air in the vicinity to a shop floor or any other specific locations like tanks, sanding machines, or laboratory hoods.

  7. Microducts - Wikipedia

    en.wikipedia.org/wiki/Microducts

    As indicated in GR-3155, cable is typically placed into the duct in one of three ways: It may be pre-installed by the duct manufacturer during the extrusion process. It may be pulled into the duct using a mechanically assisted or hand-drawn pull line. It may be blown into the duct using a high air volume cable blowing apparatus.

  1. Ads

    related to: 3 inch flexible air duct hose